Avaya 03-300430 Benutzerhandbuch

1000

ABRT

System resources required to run this test are not available. The port may 
be busy with a valid call. This result is also reported for the system’s 
Music-On-Hold port when it is off-hook, which it usually is.

1. Enter display port location to determine the station’s extension. 

Enter status station extension to determine the service state of 

the port. If the port is active, wait until it is idle.

2. Retry the command at 1-minute intervals up to 5 times.

1004

ABRT

The port was seized by a valid call during the test.

1. Use display port location to determine the station extension. 

Use status station to determine the service state of the port. If the 

port is active, wait until it is idle.

2. Retry the command at 1-minute intervals up to 5 times.

1005

ABRT

The test was aborted due to a configuration problem. This test may not be 

applicable, or it may be disruptive to terminal equipment other than a voice 

terminal (for example, the modem pool member or Music On Hold).

1018

ABRT

The test has been disabled by administration. The default for the Test field 
on the station screen is y. Determine why this field was set to n on this 
station. It may be due to the ringing application Test #48, which can be 
customer or terminal disturbing.

1. To enable the test for the particular analog station being tested, enter 

change station extension and set the Test field on the station to 

y.

1392

ABRT

This port is currently a TTI port and the test will not execute on it.

1. Verify that the port is a TTI port using either display port, which 

shows that the port is a TTI port) or list config, which shows a t for 

the port.

2. If the port is not a TTI port, escalate the problem.  If both commands 

indicate that the port is a TTI port, the abort is correct for the test, and 
no action is necessary.

 2 of 3