ResMed S8 ESCAPE SYSTEM Benutzerhandbuch

20

•

Switch on the 

S8 E

SCAPE

 and wait until you see the standby (Ramp) screen.

•

Hold the Data Card with the arrow facing up and insert it into the slot in the Data 
Card module (

H-1). 

•

Push the card in smoothly until it stops moving (

H-2) and messages start 

appearing on the LCD.

•

Data copying starts automatically when the Data Card is inserted into the Data 
Card module.

•

The “Card Inserted Please Wait” message is displayed on the 

S8 E

SCAPE

 

LCD 

while data is being copied. Copying takes approximately five seconds.

•

The “Copy Complete Remove Card” message is displayed on the LCD when 
copying has finished. 

•

Remove the Data Card from the Data Card module.

Grip the end of the Data Card and pull it out of the Data Card module (

H-3). 

Your Data Card should be stored in its mailback envelope when not in use.

A bubble mailer envelope is provided to ensure safe transportation of the Data Card. 
When mailing the Data Card to your clinician:

1. Insert the Data Card into the pocket provided on the mailback envelope. Fold up 

the mailback envelope.

2. Place the mailback envelope containing the Data Card in the bubble mailer 

envelope and seal it.

3. Make sure that your clinician’s name and address details are on the bubble mailer 

envelope, and mail it back immediately.

If your clinician has provided a Data Card with new device settings:

•

With the device in standby (Ramp) mode, insert the Data Card into the slot on 
the Data Card module. Updating will start automatically.

•

The “Card Inserted Please Wait” message is displayed on the LCD while updating 
is in progress. Updating takes approximately five seconds.

•

The “Settings Success Remove Card” message is displayed on the LCD if the 
settings were updated successfully.

•

Remove the Data Card from the Data Card module.

•

Store the Data Card in its mailback envelope when not in use.