Bosch 3.5 Benutzerhandbuch

Seite von 498
Bosch Security Systems | 2011-02
Praesideo 3.5 | Installation and User Instructions | 9 | System Configuration
en | 388
47.3.3 Press-to-talk (PTT)
Using the PTT (Press-to-talk) action, a call with a 
predefined priority based on a call macro can be started 
in one or more predefined zones or zone groups. When 
the activator of a PTT action is released, the call is 
stopped after completion of the running phase of the 
call. See figure 47.10 for an overview of the Action 
programming 
page for a PTT key. Configuring a PTT 
action is similar to configuring a Call activation key action 
(see section 47.3.4).
The PTT keys of call stations and call station keypads 
are linked to the status LEDs (see section 15.3 and 
18.2.4). Only one PTT key can be active at the same 
time.
47.3.4 Call activation key
Using the Call activation key action, a call with a 
predefined priority based on a call macro can be started 
in one or more predefined zones or zone groups. It is 
also possible to activate a predefined control output. 
When the activator of a Call activation key action is 
released, the call is aborted. See figure 47.11 for an 
overview of the Action programming page for a Call 
activation key
.
If more than one action (up to a maximum of 5) is 
configured for a Call activation key, see section 43.2.5
then also multiple sets of Call macroPriority and Zones 
can be configured here.
Action type - Sets the type of action.
Call macro - Assigns a call macro to the key or 
control input.
Priority - Sets the priority of the call. The ranges of 
priorities offered depends on the type of call station 
(normal: 32 to 223, emergency: 32 to 255). When 
the priority of the Call activation key action must be 
the same as the priority of the call macro, set Priority 
to <Default>.
Available outputs - Shows the available zones, 
zone groups and control outputs. Use the dropdown 
list to choose the type of outputs that are shown.
Add/Remove buttons - Using the > and 
buttons, selected outputs can be added to or 
removed from Assigned outputs.
Assigned outputs - Shows the outputs that have 
been assigned to the key or control input.
figure 47.10: PTT (Press-to-talk) key
Note
This action can also be assigned to control 
inputs.
figure 47.11: Call activation key
Note
If the system contains call stackers, use the 
action type 
Toggle with abort on repress or 
Momentary with abort on repress, since calls are 
automatically deleted from the call stackers 
when they are aborted immediately.