Desa 5512 Benutzerhandbuch

2

For easy installation, select an existing light operated 
by a wall switch for replacement.

For best performance, mount the fi xture about 8 ft. (2.4 m) 
above the ground.

❒  Place the Mounting Bolt through the front of the 

junction box cover. Push the small gasket hole over 
the Mounting Screw.

❒  Make sure the wire connectors and wires are inside 

the junction box. Align the Mounting Screw with the 
center hole in the Mounting Strap. Secure the fi xture 
to the Mounting Strap.

❒  Push the Rubber Plug fi rmly into place.
❒  If not installed on a weatherproof box, caulk the 

wall plate and mounting surface with silicone 

❒  Adjust the lamp holders by loosening the lock nuts 

but do not rotate the lamp holders more than 180° 
from the factory setting.

Keep lamps at least 1" (2.5 
cm) from the sensor. 

Black to Black

White to White

Gasket

Connect any fi xture ground wire(s) and the cover plate 
ground screw to the junction box ground wire.

• Allow fi xture to cool before touching. The bulb and the 

fi xture operate at high temperatures.

•  Keep fi xture at least 2" (5 cm) from combustible materi-

als. Do not aim at objects closer than 3 feet. (1 m).

• Use only T3, 150W (max.) tungsten halogen 120 

VAC lamps.

❒  Remove the existing light fi xture.
❒  Install mounting strap to junction box using screws 

appropriate for your junction box.

❒  The plastic hanger can be used to hold the fi xture 

while wiring. The small end of the plastic hanger 
can be threaded through the hole in the center of 
the cover plate. The small end then goes into one 
of the slots on the mounting strap.

❒  Thread all fi xture wires through the large holes in 

the gasket as shown.

❒  Connect the junction box wires to the light fi xture 

wires as shown. Twist together and secure with 
wire connectors.

Rubber Plug

Mounting 

Bolt

For eave mount only:

❒  Swing the sensor head towards the clamp screw 

joint.

If the sensor pops out of the ball joint, loosen the 
clamp screw and push the sensor back into the ball 
joint. Tighten the clamp screw when done.

❒  Then rotate the sensor head clockwise 180° so 

the controls face down.

Controls

For under eave installation, the sensor head must 
be rotated as shown in the next two steps for proper 
operation and to avoid the risk of electrical shock. 
Also  for proper under eave operation, remove the 
protective backing from the Light Shield and stick on 
as shown below.

Controls

Controls

Clamp Screw

Light Shield 

Opening

NOTE: Lamps are included, but you will need to 
install them
NOTE: When re-lamping, turn power off and let the 
fi xture cool.
❒  Open glass covers. To remove the old bulb push the 

bulb towards the right (with fi xture as shown) until 
the left side of the bulb is clear of the left socket.

❒  To install a bulb, push the bulb into the right socket 

so the bulb fi ts completely into the left socket.

❒  Check that the bulb is seated properly.
❒  Close the glass covers.

Push the Rubber Plug 
over the mounting screw.