Monte Carlo Fan Company 5KBR54 Benutzerhandbuch

Loosen 3 screws with key slots and remove the

screw without key slot. 

Take plate and place over the 3 screws with key

slots  and twist to hold in place. Replace the

screw removed and tighten all 4 screws secure-

ly holding the plate.

Loosen 3 screws with key slots. Attach fitter by

placing over screws and twisting clockwise into

place. Tighten all 3 screws securely.  

Plug white wire from fan to white wire  from

light kit. Then plug black from fan to black from

light kit.

Attach glass by locating dimples in light kit and

aligning it with the groves in glass and twisting

clockwise till tight.

Install the 2 50 watt halogen bulbs. Do not

touch bulb surface as oily residue from skin can

cause the bulb to explode.

Make wire connections to power source using

wire nuts provided.  Make sure that no filiments

are outside of the wirenut. After making the

wire connections, the wires should be spread

apart with the grounded conductor and the

equipment-grounding conductor on one side of

the outlet box and ungrounded conductor on

the other side of the outlet box.

Attach blade brackets to blades using the blade

bracket screws and washers provided.

Remove the shipping stabilizer plate and throw

away (see insert). The screws, washers and

motor pads are pre-installed to the blade hold-

ers. Attach blade assembly to motor and tighten

screws securely.

Make wire connections as per above diagram.

Connect the white wire from the fan to the

White or Neutral wire from the power source.

Connect the black wire from the fan to the

Black or hot wire from the power source.

Connect all Green / Yellow wires from the fan,

Downrod and mounting bracket to the Ground

wire from the house.  

House

Fan

Black

White

Green

Black

White

Green(downrod)
Green(Bracket)

Lift Canopy to ceiling aligning the key hole slots

with the screws on the bottom of the Mounting

bracket.  Rotate the canopy Counter Clockwise

to lock in place.  Tighten the screws to secure

the Canopy.  See inset for Keyhole shape

Re-install safety bar removed in step. 3 by

placing safety bar on screws, sliding into place,

and tightening the 2 screws.