BOB MA0410 Merkblatt

Congratulations on your purchase of the BOB Warm Fuzzy. It is

designed to provide your child with added comfort. Proper installation

and care will provide years of reliable service.

If you are unclear on any point, contact your dealer or BOB before

use.

Warnings
. Installation of the Warm Fuzzy requires removal and reinstallation

of the safety harness straps. It is imperative the safety harness

straps are reinstalled correctly. Failure to correctly install the safety

harness can result in your child not being properly secured in the

stroller and possible injury.

. These instructions are written specifically for the installation of the

Warm Fuzzy in a BOB Stroller. If you are installing the Warm Fuzzy

in another brand of stroller, you need to insure that it is installed

correctly and does not interfere with the proper function of the child

restraint system. Failure to do so can result in injury to your child.

1. Figure 1 illustrates the components of the safety harness system.

To correctly install the Warm Fuzzy, you will need to first remove the

safety harness as follows:

A) Unfasten the crotch and

sternum strap buckles (note

older model strollers do not

have sternum straps).

B)  Remove the harness straps

from the ladderlocks by

threading backwards through

ladderlocks.

C)  Position the straps so they

are not in the seat area where

the Warm Fuzzy will be placed.

2. You are now ready to place

the Warm Fuzzy in the stroller

seat. There are three slots in

the Warm Fuzzy. Place the

Warm Fuzzy in the seat so the

two parallel slots are located

on the seat back as shown in

figure 2. Next, locate the crotch

strap in figure 2 and route it

through the single slot as

shown. Make sure harness

straps are placed above the

Warm Fuzzy.

3.  With the harness straps

above the Warm Fuzzy,

connect the crotch buckles to

the crotch strap, as shown in

figure 3. Make sure the straps

are not twisted.

4)  Locate the ladderlocks

behind the upper slots in the

Warm Fuzzy, figure 2, and

expose them so you can attach

the harness strap. Attach the

harness strap by threading it

through the back of the ladder

lock upper slot as shown in

figure 4. Next thread it through

the lower slot from the front

side. Repeat this sequence for

both ladderlocks. When installed correctly it will look like figure 5.

5)  Figure 6 shows the Warm Fuzzy and Safety Harness correctly

installed. To properly secure your child in the stroller, refer to the

Owner’s Manual supplied with

your stroller.

Hand wash warm, dry flat, do

not dry clean or iron.

BOB Trailers Inc. takes pride

in its workmanship and strives

to manufacture the best

products possible. Therefore,

we warranty the Warm Fuzzy

against defects in material and

workmanship subject to the

conditions listed below. Since

no product is indestructible, it

does not cover defects

attributable to or resulting from

normal wear, abuse or

alteration.

(800) 893-2447  www.bobgear.com  email- bob@bobgear.com

Phone: (805) 541-2554 Fax: (805) 543-8464,  

3641 Sacramento Dr. #3  San Luis Obispo, California 93401

1

MA0410

 

warm fuzzy instructions

Fig. 3 Crotch Strap and

Buckles Installed

Fig. 6 Warm Fuzzy Correctly

Installed

Fig. 1 Safety Harness System

Fig. 2 Warm Fuzzy In Seat

Fig. 5 Straps Installed Correctly

. The Warm Fuzzy is

warranted for one year from

the date of original

purchase.

. Warranty is only valid for

the original purchaser.

. Proof of purchase is

required to exercise this

warranty.

. Labor and freight charges

are not included.

. Normal wear, neglect,

abuse, accidents, and

improper use are not

covered by this warranty.

. Warranty claims must be

made through an

authorized dealer.

. This warranty is limited to

the repair or replacement

of the defective part. BOB

shall in no event be

responsible for

consequential or special

damages.

. This Limited Warranty is the

only express or implied

warranty applicable to

BOB.  Any implied

warranties, including

warranties of

merchantability and fitness

shall be limited in scope

and duration in accordance

with this limited warranty.

Fig. 4 Install Harness Straps