Cardinal Gates door lock Merkblatt

Install one-way stop bracket (I) on one side of

latch if you wish to have gate open in only one

direction.

REPEAT AT

BOTTOM OF

GATE

LOOSEN AT TOP AND

BOTTOM OF GATE TO

ADJUST GATE WIDTH

MOUNT LATCH

ASSEMBLY WITH

SCREWS

1. Install hinge

bracket (A) to wall

(stationary side of

gate) using Phillips

screw (C)

beginning 6½”

above floor

surface.

(Use ruler on left

edge of this sheet

to measure from

floor)

 2.  Install second

screw (C) in

top of hinge

bracket

securing it to

the wall.

THIS SIDE OF GA

TE HAS THREE (3) HOLES

3.  Insert eye bolts (D) into top and bottom

of hinge side gate (side with three holes).

Be sure nuts are tight.

4.  Hang gate by inserting hinge rod (B), through top

of mounted hinge bracket (A), through upper plastic

shoulder washer (E), through both eye bolts, through

lower plastic shoulder washer (E), and finally through

bottom of hinge bracket.  To secure hinge, insert

key ring (H) through hole in end of hinge rod.

5.  Use Allen wrench (F) to unscrew set screws on

top and bottom of gate to extend gate to fill door

opening. ONLY LIGHTLY TIGHTEN AND LEAVE

SHIPPING TABS IN PLACE NOT TO MAR GATE

FINISH. You will remove shipping tabs during final

tightening.

6.  Hold latch assembly (G) against opposite

wall and extend gate until at least ½” of

safety bracket will interlock with flange

of latch. Mark position of latch assembly

screw holes with pencil.  Swing gate out

of way and mount latch assembly to wall.

Check closure of gate and tighten set

screws from STEP 5 by removing shipping

tabs to secure gate width.

GATE IS RECOMMENDED FOR CHILDREN UP TO 24 MONTHS.