GarrettCom 6K16 Benutzerhandbuch

Magnum 6K16-Series Managed Fiber Switch Installation and User Guide (04/06) 

 

17

.

.

The 4-port @10Mb ST fiber modules behave the same as the 4@100Mb ST 

fiber modules except for the 10Mb speed. For ports numbering, ports 1, 2, 5, 6 are 

present, ports 3, 4. 7, 8 are not present.  There is also a similar 100Mb fiber SC module. 

The default setup on 10Mb, fiber module is half-duplex, which allows the 

Magnum 6K16-Series Switch to connect to any 10Mb hub or media converter or almost 

any other device with a 10Mb fiber Ethernet port. The default setting of 100Mb, fiber 

module is full duplex. User mode-control per port through the MNS “port settings” 

software is the same as the other 6K16-Series modules.  

The fiber ports support fiber cabling distances according to the 10BASE-FL 

and 100BASE-FX standards, i.e., 2km distance for multi-mode fiber. (Single-mode for 

up to greater distance may be available as a special order, request quote). 

 

The Magnum 6K16-Series offered a wide option Gigabit speed with multiple 

choice for the modular slot. While up to two Gigabit modules (maxm.) can be configured 

in the modular slot. The Gigabit port option for the modular slot comes in couple of 

different configuration. The two Giga port has been offered as GBPM-2OTX (fiber or 

RJ-45), whereas the single Gigabit module comes in flavor of G+4(10/100 RJ-45 ports) 

or G+2 (100Mb fiber ports) as shown below in the figure. 

 

 

                                                                    

                    

The 6K16-Series Modules provide a GBIC opening for insertion of industry-standard 

GBICs to provide Gigabit (Gb) media flexibility. GBIC models are available for both 

multi-mode (550m) and single-mode (10, 25, 40, 70)km fiber options, and for Gigabit 

copper as well, with new models appearing often. 

 

 

 

1                                          5