Majestic Appliances 360DVSR Benutzerhandbuch

3

This gas appliance should be installed by a qualified installer, 
preferably NFI or WETT (Canada) certified, in accordance 
with local building codes and current CSA-B149.1 Installation 
Codes for Gas Burning Appliances and Equipment. If the unit 
is being installed in a mobile home, the installation should comply 
with the current CAN/CSA Z 240.4 code. For U.S.A. Installations, 
follow local codes and/or the current National Fuel Gas Code, 
ANSI Z223.1/NFPA 54.
FOR SAFE INSTALLATION AND OPERATION PLEASE 
NOTE THE FOLLOWING:

1.  This fireplace gives off high temperatures and should be located 

out of high traffic areas and away from furniture and draperies.

2.  Children and adults should be alerted to the hazards of high 

surface temperatures of this fireplace and should stay away 
to avoid burns or ignition of clothing.

3.  CAUTION: Due to high glass surface temperature, chil-

Proposition 65 Warning: Fuels used in gas, wood-
burning or oil fired appliances, and the products of 
combustion of such fuels, contain chemicals known to 
the State of California to cause cancer, birth defects 
and other reproductive harm.
California Health & Safety Code Sec. 25249.6

Remove any plastic from trim parts before turning the 
fireplace ON.
It is normal for fireplaces fabricated of steel to give off 
some  expansion  and/or  contraction  noises  during  the 
start up or cool down cycle. Similar noises are found with 
your furnace heat exchanger or car engine.
It is not unusual for your gas fireplace to give off some 
odor the first time it is burned. This is due to the curing of 
the paint and any undetected oil from the manufacturing 
process. 
Please ensure that your room is well ventilated - open 
all windows.
It is recommended that you burn your  fireplace for at least 
ten (10) hours the first time you use it. If the optional fan 
kit has been installed, place the fan switch in the “OFF” 
position during this time.

11. When the fireplace is installed directly on carpeting, vinyl 

tile, or any combustible material other than wood, it must be 
installed on a metal or wood panel extending the full width 
and depth of the fireplace.

12. This fireplace requires adequate ventilation and combustion 

air to operate properly. 

13. This fireplace must not be connected to a chimney flue serving a 

separate solid fuel-burning fireplace.

14. When the fireplace is not in use, it is recommended the gas 

valve be left in the “OFF” position. 

�������

�

��������������

������������

������������������

�������������

��������������������

���������������

4.  Under no circumstances should this fireplace be modified. 

Parts removed for servicing should be replaced prior to 
operating this fireplace again.

5.  Installation and any repairs to this fireplace must be per-

formed by a qualified installer, service agency or gas sup-
plier. A professional service person should be contacted to 
inspect this fireplace annually. Make  it a practice to have 
all of your gas fireplaces checked annually. More frequent 
cleaning may be required due to excess lint and dust from 
carpeting, bedding material, etc.

6.  Control compartments, burners and air passages in this fire-

place should be kept clean and free of dust and lint. Make 
sure the gas valve and pilot light are turned off before you 
attempt to clean this fireplace.

7.  The venting system (chimney) of this fireplace should be 

checked at least once a year, and if needed, your venting 
system should be cleaned.

8.  Keep the area around your fireplace clear of combustible 

materials, gasoline and other flammable vapor and liquids. 
This fireplace should not be used as a drying rack for cloth-
ing, nor should Christmas stockings or decorations be hung 
on or around the fireplace.

9.  Under no circumstances should any solid fuels (wood, coal, 

paper or cardboard, etc.) be used in this fireplace.

10. The flow of combustion and ventilation air must not be ob-

structed in any way.