Regency P42-NG3 Benutzerhandbuch

Regency P42-3 Zero Clearance Direct Vent Gas Fireplace

1) Remove the logs from the box and carefully

unwrap them. The logs are fragile, handle
with care. Do not force into position.

2) Place the rear log on the rear log support in

the back of the unit with the flat side of the
log facing the back of the unit. Carefully
push the log down onto the pins.

3) Sprinkle the vermiculite on the sides and

front of the fireplace bottom being careful
not to get any into the air shutter or the
burner ports (burner ports are the little
holes in the top of the burner). The vermicu-
lite is used to cover the sheet metal and
hardware on the firebox floor and burner
assembly.

4) Pull off ember size pieces of rockwool and

gently place them around the whole burn-
er. Do not compress the rockwool, leave it
loose for the most realistic looking embers.
Refer to the diagrams below for correct
placement of rockwool on the Natural Gas
and Propane units.

5) Place the front logs in the unit, aligning the

holes on the underside of the logs with the
log support pins in the front of the unit.
Carefully push the logs down onto the pins.
(Hint: Install the front right side first.)

6) Place a few embers under the front logs

and a few under the front part of the burner
assembly to make it look like fallen embers.

7) Test for pilot ignition.

8) Install the door and louvers.