Regency P40 Benutzerhandbuch

Regency

®

 P40 Direct Vent Gas Fireplace

MAINTENANCE

1)  Unplug the power source.

2)  Remove the Power Module by lifting it up 

off of the velcro and pull out.

3)  Remove the Power Module cover by 

removing the 2 screws, one on each side 
of the box.

4)  Unplug all wires connected to the Power 

Module (J1, J2 & J3 on the power module 
circuit board).

5)  Pull Power Module off of pins and replace.

6)  Reverse steps to re-install. 

3)  Remove the Control Module by lifting it up 

off of the velcro and pull out.

1)  Unplug the power source.

2)  Remove the Power Module by lifting it up 

off of the velcro and pull out.

4)  Remove the Heat Shield from the Control 

Module by removing the 2 screws.

5)  Unplug all wire harnesses and manual 

control box cable plugged into the Control 
module.

6)  Replace the Control Module and reverse 

steps to re-install. 

1)  Unplug the power source.

2)  Remove the Power Module by lifting it up 

off of the velcro and pull out.

3)  Remove the Power Module cover by 

removing the 2 screws, one on each side 
of the box.

4)  Replace the 9V and AA battery and reverse 

steps to re-install.

(within Power Module)