Quadra-Fire SANTAFEI-CE-MBK Benutzerhandbuch

Page 28

October 27, 2011

R 

7069-101B

Parts Included in Kit: 1 piece of 51mm x 914mm flex

hose, 2 hose clamps, 1 collar assembly, 1 termination cap

assembly, 1 trim ring, fasteners and air intake channel

(discard).

1.  Measure distance from floor to air vent opening in appli-

ance and mark location on wall.

2.  Use saw to cut opening in wall. Cut a 64 to 76mm open-

ing on inside wall and a 76 to 89mm opening on outside

of house.

3.  Use hose clamp to secure flex pipe to collar assembly.
4.  Slide trim ring over flex pipe and run pipe through wall.
5.  Attach  hose  to  outside  termination  cap  with  second

hose clamp.

6.  Secure termination cap to outside surface.
7.  Secure trim ring to interior wall.

Tools Needed: Phillips head screwdriver; wire cutters;

hole saw or jig saw.

Never draw outside combustion air from:

•  Wall, floor or ceiling cavity

•  Enclosed space such as an attic or garage

The leveling bolts are located at the rear of the appliance.

To access the bolts, remove the side access panels. Reach

in and turn the bolt to the desired height to level the appli-

ance. Shown in

Leveling Bolt on each Side

Flex Hose 

Hose Clamp 

Collar  

Assembly 

Hose Clamp 

Trim Ring

Termination 

Cap Assembly

Air Intake Channel (Discard)

2 inch diameter Flex Pipe

Attach Termination 

Cap to Exterior Wall

Leveling Bolt