GN National Electric CP Benutzerhandbuch

22618-4-1106

Page 29

A.  BEFORE LIGHTING smell all around the appliance area 

for gas. Be sure to smell next to the floor because some gas 

is heavier than air and will settle on the floor.

 

•  Do not try to light any appliance.

 

•  Do not touch any electrical switch.

 

•  Do not use any phone in your building.

 

•  Immediately call your gas supplier from a neighbor’s 

phone. Follow the gas supplier’s instructions.

 

•  If you can not reach your gas supplier, call the fire de-

partment.

B.  Use on the wall switch or remote control switch to turn the 

gas control on/off. Any attempted repairs or adjustments 

should be performed by a qualified service technician. Ap-

plying force or attempted repair may result in a fire or ex-

plosion.

C.  Do not use this appliance if any part has been under water. 

Immediately call a qualified service technician to inspect 

the appliance and to replace any part of the control system 

and any gas control which has been under water.

1.  STOP! Read the safety information above on this label.

2.  Set the thermostat, if used, to the lowest setting.

3.  Turn off all electric power to the appliance. Turn off elec-

trical control switches to “O.”

4.  This appliance is equipped with an ignition device that au-

tomatically lights the burner. Do not try to light the burner 

by hand.

5.  Remove  the  front  access  panel  below  the  glass  door  by 

pulling both sides forward simultaneously.

6.  Turn gas line valve to “ON.”

7.  Wait five (5) minutes to clear out any gas. Then smell for 

gas, including near the floor. If you smell gas, STOP! Fol-

low  “A”  in  the  safety  information  above.  If  you  do  not 

smell gas, go to the next step.

8.  Replace the front access panel, press both sides of the panel 

until both lock position.

9.  Turn on electric power to the appliance. Turn on electric 

control switches to “I.”

10.  Set thermostat to desired setting (if available).

11.  If  the  appliance  will  not  operate,  follow  the  instructions 

“TO TURN OFF GAS TO APPLIANCE,” and call your 

service technician or gas supplier.

OFF

ON

1.  STOP! Read the safety information above.

2.  Set the thermostat, if used, to the lowest setting.

3.  Turn off electric power to the appliance.

4.  Remove front access panel.

5.  Turn gas line valve to “OFF.”

6.  Replace front access panel.