Roberts Gorden TF-200 Benutzerhandbuch

51

Installation Code and Annual Inspections: 
All installation and service of ROBERTS GORDON

®

 

equipment must be performed by a contractor 
qualified in the installation and service of equipment 
sold and supplied by Roberts-Gordon LLC and 
conform to all requirements set forth in the 
ROBERTS GORDON

®

 manuals and all applicable 

governmental authorities pertaining to the 
installation, service and operation and labeling of the 

equipment.

To help facilitate optimum performance and safety, 
Roberts-Gordon LLC recommends that a qualified 
contractor conduct, at a minimum, annual 
inspections of your ROBERTS GORDON

®

 equipment 

and perform service where necessary, using only 
replacement parts sold and supplied by Roberts-
Gordon LLC.

Do not store or use flammable objects, liquids or vapors near the heater. 
Immediately remove these items if they are present.

Maintain the clearances to combustibles.

Do not hang anything from, or place anything on, the heater.

Make sure nothing is lodged underneath the reflector, in between the tubes or 
in the decorative or protective grilles (included with select models).

Immediately remove objects in violation of the clearances to combustibles.

Support reflector with reflector hanger and support strap.

Reflector must not touch tube.

Make sure there is no dirt, sagging, cracking or distortion.

Do not operate if there is sagging, cracking or distortion.

Make sure reflectors are correctly overlapped. 

Clean outside surface with a damp cloth.

Venting must be intact. Using a flashlight, look for obstructions, cracks on the 
pipe, gaps in the sealed areas or corrosion.

The area must be free of dirt and dust.

Remove any carbon deposits or scale using a wire brush.

Inlet must be intact. Look for obstructions, cracks on the pipe, gaps in the 
sealed areas or corrosion.

The area must be free of dirt and dust. Clean and reinstall as required.

Make sure there are no cracks.

Make sure tubes are connected and suspended securely.

Make sure there is no sagging, bending or distortion.
Clean or replace as required.