Empire Products SR-18T-3 Benutzerhandbuch

Page 10

16009-1-0504

Refer to Figures 7, 8 and 9 for measurements in order to locate (4)
mounting holes on wall. Figures 7, 8 and 9 are the front views of
the heaters.

1. Remove lower louver from casing assembly (2 screws).
2. Remove reflector from casing assembly (2 screws).
3. Remove upper louver from casing assembly (2 screws).

1. After locating mounting holes, attach (4) #10 x 1" (25mm)

screws provided into the wall. Do not completely tighten
screwheads to the wall, leave a 1/8" (3mm) gap between
screwheads and wall.

2. Mount heater onto the (4) screwheads and complete

tightening screwheads into the wall.
Attention!  Use the following steps to properly align the
upper louver and the reflector with the heat shield.
a. When replacing upper louver, be sure the bottom lip of

upper louver goes behind the heat shield.

b. When replacing reflector, be sure the top lip of reflector

goes in front of the heat shield.

3. Connect the gas line.

1. After locating mounting holes, drill (4) 5/16" (8mm)

diameter holes into the wall.

2. Insert (4) plastic expansion anchors provided into the

holes.

3. Tighten (4) #10 x 1" (25mm) screws provided into the

plastic expansion anchors. Do not completely tighten
screwheads to the plastic expansion anchors, leave a 1/8"
(3mm) gap between screwheads and plastic expansion
anchors.

7 13/16"

(198mm)

11 13/16"

(300mm)

1 3/32"

(28mm)

18 7/8"

(479mm)

22"

(559mm)

4 1/32"

(102mm)

2"MIN (51mm)

2"

(51)

2"

(51)

18"

(457mm)

2"

(51)

14"

(356mm)

2"

(51)

1 3/32

(28mm)

18 7/8"

(479mm)

22"

(559mm)

2" (51mm)

2 1/32 (52mm)

4 1/32"

(102mm) MIN

24 1/8"

(613mm)

20 1/8"

(511mm)

2"

(51)

22"

(559mm)

2"

(51)

1 3/32"

(28mm)

18 7/8"

(479mm)

4 1/32

(102mm)

MIN

2 1/32" (52mm)

2" (51mm) MIN