Hampton Direct H15-LP1 Benutzerhandbuch

8

Hampton

®

 H15-1 Direct Vent Freestanding Gas Stove

 
When selecting a location for your stove, ensure 
that the clearances listed above are met as well 
as ensuring that there is adequate accessibility 
for servicing and proper operation.

1)  Ensure that structural members are not cut 

or weakened during installation.

2)  Ensure proper grounding using the #8 

ground lug provided.

3)  Appliance must be anchored to the fl oor 

with the supplied anchoring methods. 

The combustion air from this appliance is drawn 
from outside the building through the outer fl ue. 
Extra provision for combustion air inside the 
room is not required.

A) Cross 

Corner 

B) Room 

Divider

C) Island 

 

D) Flat 

on 

Wall

E) 

Flat on Wall Corner 

F) Flush 

with 

Wall/Alcove

For Vent Termination requirements, see the 
"Exterior Vent Terminal Locations" section.

Qty. Description
1  Fan Assembly c/w green wire attached 
1 Thermodisc
1 Fan 

Speed 

Control

1 Grommet

1)  Remove the rear access panel on the back 

of the stove by removing the 2 screws under 
the rear panel, then lift rear panel off of 2 
bolts at the top. Take care not to cut wires 
when lowering the panel.

2)  Disconnect the red and grey wires.

4)  Remove the nylon hole plug from the control 

panel.

5)  Install the fan speed controller onto the 

control panel and secure with nut and 
washer. Connect the red and black wires 
from the wire harness to speed controller. 
NOTE: Speed control wires must be in 
the down position when control panel is 
in place.

6)  Push black knob onto speed control.

3)  Remove  the Top Control Panel Assembly 

by removing the three screws. 

7)  Re-attach control panel with 3 screws, 

reversing step 3.

8)  Slide Thermodisc into the bracket on the left 

side of the rear fi rebox.

* 12' max. only if vertical height is achieved.