Dimplex DFG3033 Benutzerhandbuch

7

①

  Prior to the first use of the 

fireplace verify the following:
•  Are the circuit breakers for the 

unit on?
•  Are the light bulbs in your 

fireplace loose? (To check, follow 

the instructions for replacing the 

light bulbs under the Maintenance 

section of this manual.) 

②

  The heater on your fireplace 

may emit a slight, harmless odor 

when first used.  This odor is a 

normal condition caused by the 

initial heating of internal heater 

parts and will not occur again. 

③

  The information regarding the 

model of your fireplace can be 

found on the rating plate located 

on the front of the unit.

NOTE 1:  a 15 amp, 120 

volt circuit is required.  a 

dedicated circuit is preferred 

but not essential in all cases.  a 

dedicated circuit will be required 

if, after installation, the circuit 

breaker trips or fuse blows on a 

regular basis when the heater is 

operating.  additional appliances 

on the same circuit may exceed 

the current rating of the circuit 

breaker.

 WARNINg:  Ensure the power 

cord is not installed so that it is 

pinched or against a sharp edge 

and ensure that the power cord is 

stored or secured to avoid tripping 

or snagging to reduce the risk 

of fire, electric shock or injury to 

persons.

Construction and electrical 

outlet wiring must comply with 

local building codes and other 

applicable regulations to reduce 

the risk of fire, electric shock and 

injury to persons.
Do not attempt to wire your own 

new outlets or circuits.  To reduce 

the risk of fire, electric shock or 

injury to persons, always use a 

licensed electrician.
This section provides instructions 

for selecting a location and 

preparing the site to install the 

fireplace into your Dimplex mantel 

surround.

select a suitable location that 

1. 

is not susceptible to moisture 

and is away from drapes, 

furniture and high traffic.