Desa GS38 Benutzerhandbuch

www.desatech.com

113195-01C

Auto Shutoff Feature

1. If the average room temperature exceeds

82 degrees Fahrenheit (28 degrees Centi-

grade), the hand-held remote control will

perform a safety override and shut the

fireplace off. This feature is not available

in the MANU mode.

2. The receiver continuously receives signals

from the hand-held remote to control the

room temperature. If the hand-held remote

is misplaced, obstructed or for any reason

cannot transmit to the receiver, the receiver

will shut off the fireplace after 8 minutes.

Key Pad Lock Feature

This feature allows the user to lock/unlock

the keypad on the hand-held remote in the

MANU or AUTO mode to prevent inadvertent

operation (i.e. children operating the hand-held

remote control, etc.). The keypad is locked in

either on or off. Press the POWER and LOCK

buttons together to turn the unit on or off.

OPTIONAL BLOWER

OPERATION

Locate the blower switch by opening lower lou-

ver on fireplace insert. Blower switch is located

at lower left inside louver door.

This thermostat-controlled blower has three

settings: ON, OFF and AUTO. In the ON posi-

tion, the blower will operate constantly. In the

OFF position, the blower will not operate. In

the AUTO position, the blower will start when

the thermostat senses a sufficient increase in

firebox temperature.
Note:

Your gas logs and thermostat blower

will not turn on and off at the same time. The

fireplace insert may run for several minutes

before the blower turns on. After the heater

modulates to the pilot position, the blower will

continue to run. The blower will shut off after

the firebox temperature decreases.
Note:

It is safe to operate fireplace insert with

blower turned off. However, the blower helps

distribute heated air from the fireplace insert.

OpERATiNG FiREplAcE

iNSERT

Continued

iNSpEcTiNG BURNERS

Check pilot flame pattern and burner flame pat-

terns often.

PILOT FLAME PATTERN

Figure 36 shows a correct pilot flame pattern.

Figure 37 shows an incorrect pilot flame pattern.

The incorrect pilot flame is not properly heating

the thermocouple. When the thermocouple cools,

the heater will shut down.

If pilot flame pattern is incorrect, as shown in

Figure 37

• turn heater off (see To Turn Off Gas to Appli-

ance, page 20)

• see Troubleshooting, page 25
Note:

The pilot flame on natural gas units will

have a slight curve, but flame should be blue and

have no yellow or orange color.

Figure 36 - Correct Pilot Flame Pattern

Pilot Burner

Figure 37 - Incorrect Pilot Flame Pattern

Pilot Burner

Natural Gas

Pilot Burner Thermocouple

Pilot Burner

Thermocouple

Natural Gas

Propane/LP Gas