Desa CEF26BN Benutzerhandbuch
www.desatech.com
116863-01B
7
FINISHING
Combustible Finishing Material :
Materials
made of or surfaced with wood, compressed paper,
plant fibers, plastics or any material capable of
igniting and burning, whether flame proofed or not,
plastered or unplastered (this includes drywall).
Noncombustible Finishing Material :
Noncombustible Finishing Material :
Mate-
rials which will not ignite and burn. Such materials
are those consisting entirely of steel, iron, brick,
tile, concrete, slate, glass or plasters or combina-
tions thereof or have a fire rating of zero.
WARNING: Grills on this heater
cannot, in any way, be covered as
it may create a fire hazard,
FINISHING CHECKLIST
• Power supply service must be completed prior
to finishing to avoid reconstruction.
• Grilles and air openings cannot be covered in
any circumstances.
Note:
The heater is a zero clearance fireplace and
may be finished with combustible or noncombus-
tible finishing materials.
When using paint or lacquer to finish the mantel, they
When using paint or lacquer to finish the mantel, they
must be heat resistant to prevent discoloration.
OPERATING
INSTRUCTIONS
The controls (see Figure 4) are located behind
the grill above glass panel and can be accessed
by pulling the grill from the top, forward and
down.
1. Main ON/OFF power switch: This switch
is located at the furthest right corner on
the control panel. Turn the switch to ON
and unit will be ready to operate. The "|"
indicates ON and "O" indicates OFF.
Figure 4 - Controls For Electric Fireplace
Main ON/OFF
Power Switch
Power Switch
Display ON/OFF Knob
Heater Temperature
Control Dial
Control Dial
IMPORTANT: Once you turn the
main switch to the ON posi-
tion, the remote control can no
longer be used. In order to use
the remote control, you must
keep the main ON/OFF switch
in the OFF.
2. Display ON/OFF knob: There is a flame
icon directly below this knob. After you
turn the Main Power switch to the ON
position, turn the Display Knob to desired
setting. Both the logset and the flame will
light up inside the fireplace
3. Heater Switch and Control Dial: The dial is
located to the furthest left on the front panel
with a temperature icon directly below it. To
turn the heater on, flip the Heater Switch to
ON position (the "|" indicates ON and "O"
indicates OFF) then turn the dial clockwise
past the number 8. You should hear a small
clicking sound indicating the heater has
started and heat will emit through the vents
located in the middle of the control panel. To
turn off heater, turn the temperature dial
counter clockwise past number 1 and flip
the Heater Switch to OFF position. Heat will
stop coming out of the vent.
To increase the desired temperature, turn
the temperature dial clockwise towards
Number 8.
To decrease the desired temperature, turn
the temperature dial counter clockwise
towards number 1. The heater has built-in
thermostat so it will shut off automatically
once the set temperature is reached. It will
also turn on automatically if the room tem-
perature drops below the set temperature
on the dial.
Note:
When the heater is turned on for the
first time, it may release a slight, harmless
odor. This odor is a normal occurrence
caused by the initial heating of the internal
heating elements and should not occur
again.
4. Backlight Control Knob: The backlight
control knob allows you to brighten or dim
the light that shines on the logs.
OPERATING BY REMOTE CONTROL
1. Plug in your electric fireplace and it will
beep once. This means you have power
and your remote is ready to operate your
electric fireplace.
Heater ON/OFF
Power Switch
Power Switch
Backlight Control Knob