Desa (V)T32EN SERIES Benutzerhandbuch

Seite von 40
www.desatech.com
111987-01D
8
5.  Turn equipment shutoff valve clockwise 
 to the OFF position (see Figure 49). 
Do not force.
6.  Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the floor.
If you smell gas, STOP! Follow “B” in the
safety information in column 1. If you don’t
smell gas, go to the next step.
7.  Turn  equipment  shutoff  valve  counter-
clockwise 
 to the ON position. Do 
not force.
8.  Close lower louver panel.
9.  Turn on all electric power to the appli-
ance.
10.  Turn the wall switch to the ON position.
11.  Visually locate the pilot. The ignitor should
begin to spark and the main burner should 
ignite once flame appears at pilot.
• If lighting the appliance for the first time
each season, it may take several attempts
before the supply gas can reach the pilot
and main burners.
• If  the  appliance  will  not  stay  lit  after
several attempts, follow the instructions 
To Turn Off Gas To Appliance, page 29, 
and call your service technician or gas
supplier.
Figure 48 - Turning Equipment Shutoff 
Valve to the OFF Position
Equipment 
Shutoff Valve
Adjustment 
Screw
Figure 49 - Pilot
Sensing 
Rod
Pilot 
Burner
Ignitor
OPERATING FIREPLACE
FOR YOUR SAFETY 
READ BEFORE LIGHTING
 WARNING: If you do not fol-
low  these  instructions  exactly, 
a  fire  or  explosion  may  result 
causing property damage, per-
sonal injury or loss of life.
A.  This appliance is equipped with an ignition 
device which automatically lights the pilot.
Do not try to light by hand.
B.  BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle on the floor.
 WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not
use any phone in your building.
• Immediately  call  your  gas  supplier
from a neighbor's phone. Follow the gas 
supplier's instructions.
C.  Use only your hand to push in or turn the
gas control knob. Never use tools. If the 
knob will not push in or turn by hand,
don't try to repair it, call a qualified service
technician. Force or attempted repair may
result in a fire or explosion.
D.  Do not use this appliance if any part has
been  under  water.  Immediately  call  a
qualified service technician to inspect the
appliance and to replace any part of the
control system and any gas control which
has been under water.
LIGHTING 
INSTRUCTIONS
NOTICE: During initial operation 
of new heater, burning logs will 
give off a paper-burning smell. 
Orange flame will also be pres-
ent. Open damper or window to 
vent smell. This will only last a 
few hours.
1.  STOP!  Read  the  safety  information,
above.
2.  Turn off all electric power to the appliance.
3.  Turn wall switch to the OFF position.
4.  Open lower louver panel.