Crane Plumbing 8XSE-HA Benutzerhandbuch

3

Please Read This Before Installing Or Operating Pump. 
This information is provided for SAFETY and to PREVENT 
EQUIPMENT PROBLEMS. To help recognize this information, 
observe the following symbols:

IMPORTANT! Warns about hazards that can result 
in personal injury or Indicates factors concerned with 
assembly, installation, operation, or maintenance which 
could result in damage to the machine or equipment if 
ignored.

CAUTION ! Warns about hazards that can or will cause minor 
personal injury or property damage if ignored. Used with symbols 
below.

WARNING !  Warns about hazards that can or will cause serious 
personal injury, death, or major property damage if ignored. Used 
with symbols below.

Only qualifi ed personnel should install, operate and repair 
pump. Any wiring of pumps should be performed by a qualifi ed 
electrician.  

WARNING ! - To reduce risk of electrical shock, pumps 
and control panels must be properly grounded in 
accordance with the National Electric Code (NEC) or the 
Canadian Electrical Code (CEC) and all applicable state, 
province, local codes and ordinances. 

WARNING! - To reduce risk of electrical shock, always 
disconnect the pump from the power source before 
handling or servicing. Lock out power and tag.

WARNING! Operation against a closed 
discharge valve will cause premature bearing 
and seal failure on any pump, and on end 
suction and self priming pump the heat build 

may cause the generation of steam with resulting dangerous 
pressures. It is recommended that a high case temperature 
switch or pressure relief valve be installed on the pump body.

CAUTION ! Never operate a pump with a plug-in  type 
power cord without a ground fault  circuit interrupter.

CAUTION! Pumps build up heat and pressure 
during operation-allow time for pumps to cool 
before handling or servicing. 

WARNING! - DO NOT pump hazardous materials 
(fl ammable, caustic, etc.) unless the pump is specifi cally 
designed and designated to handle them.

Do not block or restrict discharge hose, as discharge 
hose may whip under pressure. 

WARNING! - DO NOT wear loose clothing that may 
become entangled in the impeller or other moving parts. 

WARNING! - Keep clear of suction and discharge 
openings. DO NOT insert fi ngers in pump with power 
connected.

Always wear eye protection when working on pumps.

Make sure lifting handles are securely fastened each 
time before lifting. DO NOT operate pump without 
safety devices in place. Always replace safety devices 
that have been removed during service or repair. 
Secure the pump in its operating position so it can not 
tip over, fall or slide.

DO NOT exceed manufacturers recommendation for 
maximum performance, as this could cause the motor 
to overheat.

DO NOT remove cord and strain relief. Do not connect 
conduit to pump.

WARNING! Cable should be protected at all times to 
avoid punctures, cut, bruises and abrasions - inspect 
frequently. Never handle connected power cords with 
wet hands.

WARNING! To reduce risk of electrical shock, all wiring 
and junction connections should be made per the NEC 
or CEC and applicable state or province and local 
codes. Requirements may vary depending on usage 
and location.

WARNING! Submersible Pumps are not approved for 
use in swimming pools, recreational water installations, 
decorative fountains or any installation where human 
contact with the pumped fl uid is common.

WARNING! Products Returned Must Be Cleaned, 
Sanitized, Or Decontaminated As Necessary Prior 
To Shipment, To Insure That Employees Will Not Be 
Exposed To Health Hazards In Handling Said Material. 
All Applicable Laws And Regulations Shall Apply.

 

Bronze/brass and bronze/brass fi tted pumps may 
contain lead levels higher than considered safe for 
potable water systems. Lead is known to cause cancer 
and birth defects or other reproductive harm. Various 
government agencies have determined that leaded 
copper alloys should not be used in potable water 
applications. For non-leaded copper alloy materials of 
construction, please contact factory. 

IMPORTANT! - Crane Pumps & Systems, Inc. is not 
responsible for losses, injury, or death resulting from a 
failure to observe these safety precautions, misuse or 
abuse of pumps or equipment.

SAFETY FIRST!