Kenmore 408.72012 Benutzerhandbuch

WINDOW KIT INSTALLATION
The Window Kit (included) contains three sliding pieces, and can be adjusted 

to fit most standard vertical and horizontal windows (see Figs. 1 & 1a). For 

very wide windows, use all three pieces. For very narrow windows, you may 

have to cut down the end of the piece with the hose attachment hole. Do not 

cut into the hole.

EXHAUST HOSE CONNECTION
The exhaust hose must be attached to the appropriate side of the unit given 

the desired application, either cooling or heating (see Operating Instructions). 

When changing applications, switch the adjustable air vent and exhaust hose 

holder (hose can remain attached) to the opposite sides of the unit.

This product is equipped with an LCDI (Leakage Current Detection and 

Interruption) safety plug. If power shuts off, unplug from the electrical outlet 

and make sure the cord is undamaged. If the cord is damaged, return the unit 

to a Sears Service Center for repair before using it again.

TO TEST THE SAFETY PLUG

1.  Connect the power plug to an electrical outlet.
2.  The power plug has two buttons located on the top. One button is marked 

“TEST” and the other is marked “RESET”. Press the “TEST” button; you will 

hear a click as the “RESET” button pops out.

3.  Press the “RESET” button; you will hear a click as the button engages.
4.  The power supply cord is now energized and supplying electricity to the 

air conditioner (it is indicated by a light on the plug head).

•  Under no circumstances should this device be used to turn the unit on 

or off.

•  The “RESET” button must always be pushed in (engaged) for correct 

operation.

•  The power supply cord must be replaced if it fails to reset when the 

“TEST” button is pushed in.

1.  Select a location near a window and 

electrical outlet.

2.  Position the unit in a flat, spacious location 

with a minimum of one foot of clearance 

(30 cm) between the air outlets and any 

wall or pieces of furniture.

3.  If placing the unit outside of the room to be 

cooled, position it on a flat solid surface, 

preferably in a space with overhead 

shielding from rain and the direct rays 

of the sun. Do not operate the unit in 

extremely moist areas such as a sauna.

1. POWER

Press this button to switch the unit on or off.

2. MODE

Press this button to select between Cooling (    ),
Heating (     ) or Dehumidifying (     ) mode.

NOTE: To change display between °F 

and °C, press the MODE button for 10 

seconds with the power off and unit 

plugged in (Standby Mode). You will 

hear a beep when the change occurs.

3. TEMP+

•  Pressing this button in cooling 

mode increases the desired room 

temperature setting by 1°F (1°C) up to 

a maximum setting of 86°F (30°C).

•  Pressing this button in heating 

mode increases the desired room 

temperature setting by 1°F (1°C) up to 

a maximum setting of 77°F (25°C).

 

Window kit

Min: 19 in.

(48 cm)

Max: 50 in.

(127 cm)

Vertical Window

Horizontal Window

Window kit

Min: 19 in.

(48 cm)

Max: 50 in.

(127 cm)