Soleus Air SG-WAC-10ESE-F Benutzerhandbuch

 8 

1.  Place the air conditioner on the sill with the bottom 

mounting rail against its back edge. Center the air con-
ditioner and close the window securely behind the top 
mounting rail. The air conditioner should be slightly 
tilted to the outside area. Use a level; about a 1/3 bub-
ble will be the correct case slant to the outside. (See 
FIG. 5 & FIG. 6) 

 
 

2.  Once the air conditioner is placed, extend both the left 

and right accordion panels to the width of the window 
SEE FIGURE 7). 

3.  Place the frame lock between the frame extensions 

and the window sill as shown (FIG. 8). Drive 
3/4” (19mm) locking screws through the frame lock and 
into the sill (FIG. 9). NOTE: To prevent window sill from 
splitting, drill 1/8” (3mm) pilot holes before driving 
screws. 

 
 
 
 
 
 
 

 
 
 
 

Now that you have installed the top rail, you can now install 
the accordion panels on each side. 
 
1.  Place the air conditioner on a hard flat surface. 
2.  Locate the accordion panels in the box. 
3.  Gently pull the free end of the accordion panel (See 

FIG. 2). Do this for both panels. 

4.  Slide the free end of the accordion panel into the side 

panel of the air conditioner (See FIG. 3 & 3A). Do this 
for each side. 

5.  Once the accordion panels are slid into place, make 

sure you leave enough space to slip on the top and 
bottom rails (See FIG. 4). Now, slide the top and bot-
tom of the side panels inside top and bottom rails (See 
FIG. 4A). Adjust the panels until they fit securely inside 
the rails