Samsung AD18B1C09 Benutzerhandbuch

Parts

Procedure

Remark

Electrical Parts

(Main PCB)

Ass’y Tray Drain.

Heat Exchanger

Fan Motor and

Cross Fan

1) Do “1”above.

2) Take all the connector of PCB upper side out.

(Inclusion Power cord)

3) Separate the outdoor unit connection wire from

the terminal block.

4) If pulling the Main PCB up. it will be taken out.

1) Do “1”, “2”, above.

Separate the drain hose from the extension
drain hose.

2) Pull tray drain out from the back body.

1) Do “1” and “2”, “3”, above.

2) Loosen two fixing earth screws of right side.

3) Separate the connection pipe.

4) Separate the holder pipe at the rearside.

5) Loosen the three fixing screws of right and left

side.

6) Lifting the heat exchanger up a little to push the

up side for separation from the indoor unit.

1) Do “1”, “2”, ”3”, “4”, above.

2) Loosen the fixing two screws and separate the

motor holder.

3) Loosen the fixing screw of fan motor.

(By use of M3 wrench)

4) Separate the fan motor from the fan.

5) Separate the fan from the left holder bearing.

DB98_05645A(1)_1 5/30/02 7:04 PM Page 4