Dometic 595 SERIES Benutzerhandbuch

7

 

3.  A 3/8” diameter hole will be needed to route the cable  

 

 

through the wall.

A 4-conductor control cable must be routed from the roof opening to 

the Comfort Control Center™.

 

.  Choose the shortest, most direct route from the 4- 

 

 

/4” (±/8”) opening to the Comfort Control Cen- 

ter™ location selected. Leave 6” of cable extending  

 

 

through the wall.

2.  The control cable that should be used is a flat, 4-  

conductor telephone cable. 

 

3.  The control cable must be terminated with two (2) RJ- 

 

 

-4C-6P telephone connectors. Refer to the crimp tool  

 

 

manufacturer for crimping instructions. 

C.  COMFORT CONTROL CENTER™ INSTALLATION

 

.  Carefully remove the base plate from the Comfort  

Control Center™. This may be accomplished by  

 

 

inserting a small screwdriver under the tab on the  

 

 

bottom edge of the front cover and gently prying. (See  

 

 

FIG. 5).

 

2.  Insert the control cable through the hole in the base  

 

 

plate and mount the plate to the wall with the two  

 

 

screws provided. Check the alignment to ensure level  

 

 

installation.

 

3.  Install the control cable RJ--4C-6P connector into the  

 

 

back of the Comfort Control Center™ and gently    

 

press onto the base plate.

A.  Remove the Air Conditioner from the carton   

 

and discard.

B.   Place the Air Conditioner on the roof.

C.   Lift and place the unit over the prepared opening using  

 

the gasket on unit as a guide. The exposed coil goes  

 

toward the rear of the RV.

D.  Place the Air Box Kit and Electronic Control Kit inside   

the RV. Both kits contain mounting hardware for the air    

conditioner and will be used inside the RV.

This completes the outside work. Minor adjustments can be