Danby DPAC 12099 Benutzerhandbuch

The power cord supplied with this air conditioner contains a device that senses damage to

the power cord. To test if your power cord is working properly, you must do the following:

Your Danby appliance is designed to be highly efficient in energy savings. Follow
these recommendations for greater efficiency. 

1) Select a thermostat setting that suits your comfort
needs and leave at that chosen setting. 

2) The air filter is very efficient in removing airborne
particles. Keep the air filter clean at all times.

3) Use drapes, curtains or shades to keep direct 
sunlight from penetrating and heating room, but do not
allow drapes or curtains to obstruct the air flow around
the unit.

4) Start your air conditioner before the outdoor air
becomes hot and uncomfortable, to avoid an initial
period of discomfort while the unit is cooling off the
room. Use of the automatic start/stop programmable
TIMER feature can be a major asset in this regard if
utilized to the fullest extent. 

5) When outdoor temperatures are cool enough, turn
the air conditioner off and use the FAN MODE on
HIGH, MED, or LOW. This circulates indoor air,
providing some cooking comfort while utilizing less
electricity. 

NOTE: The power cord supplied with this air 
conditioner contains a current leakage detection
device designed to reduce the risk of fire. In the event
the power supply cord is damaged, it cannot be
repaired and must be replaced with a new cord from
the product manufacturer. 

• Under no circumstances should this device be used
to turn the unit on or off. 

• The “RESET” button must always be pushed in
(engaged) for correct operation.

• The power supply cord must be replaced if it fails to
reset when the “TEST” button is pushed in.

1) Connect the power supply cord to an electrical outlet.

2) The power supply cord has two buttons located on
the head of the plug. One button is marked “TEST”,
and the other is marked “RESET”. Press the “TEST” 
button; you will hear a click as the “RESET” button
pops out.

3) Press the “RESET” button; you will  hear a click as
the button engages.

4) The power supply cord is now energized and 
supplying electricity to the air conditioner (on some
products this is also indicated by a light on the plug
head). 

4