Danby DPAC 12099 Benutzerhandbuch
Control Buttons:
1) Power Switch
2) Mode
3) Fan Speed
4) On / Off Timer
5) Time / Temperature Set
• Used for adjusting the timer and temperature.
• The default display on control panel is room temperature.
• When
1) Power Switch
2) Mode
3) Fan Speed
4) On / Off Timer
5) Time / Temperature Set
• Used for adjusting the timer and temperature.
• The default display on control panel is room temperature.
• When
key is pressed in cool mode, the set
temperature is displayed and may be adjusted. After 10 seconds the
display will revert back to room temperature.
• Timer setting is available from 1-24 hours by pressing the
display will revert back to room temperature.
• Timer setting is available from 1-24 hours by pressing the
key
To operate the hand held remote control you will require two “AAA”
Alkaline batteries (included).
Alkaline batteries (included).
Batteries should be replaced when:
a) No signal (beep) is heard when attempting to program the main unit.
b) The main unit does not respond to a command issued by the remote
control.
Battery replacement:
1) Slide the rear cover on the remote in the direction of the arrow.
Continue pulling (gently) until the cover separates completely from the
unit.
a) No signal (beep) is heard when attempting to program the main unit.
b) The main unit does not respond to a command issued by the remote
control.
Battery replacement:
1) Slide the rear cover on the remote in the direction of the arrow.
Continue pulling (gently) until the cover separates completely from the
unit.
Notes:
1) Do not drop the remote control.
2) Do not place the remote control in a location exposed to direct sunlight.
3) The remote control should be placed about 1 meter or more away from TV, or any electrical appliances.
1) Do not drop the remote control.
2) Do not place the remote control in a location exposed to direct sunlight.
3) The remote control should be placed about 1 meter or more away from TV, or any electrical appliances.
This Class B digital apparatus complies with canadian ICES-003.
The functions work the same as your dehumidifier’s touch controls.
Batteries: Remove the cover on the back of the remote control and insert the batteries with the (+) and (-)
poles pointing in the proper direction.
Batteries: Remove the cover on the back of the remote control and insert the batteries with the (+) and (-)
poles pointing in the proper direction.
CAUTION: Use only AAA or IEC R03 1.5 V batteries.
• Remove the batteries if the remote control is not used for a month or longer.
• Remove the batteries if the remote control is not used for a month or longer.
• Do not attempt to recharge the supplied batteries.
• All batteries should be replaced at the same time.
• Do not dispose of batteries in a fire as they may explode.
• All batteries should be replaced at the same time.
• Do not dispose of batteries in a fire as they may explode.
PLACING BATTERIES
IN REMOTE COTROL
REMOTE CONTROL FEATURES
8
2) Insert (2) batteries (AAA) following the same orientation (polarity) depicted inside the battery chamber (+ / -).
3) Re-install rear cover.
4) If the remote control will not be used for extended periods of time (vacations, etc.),
batteries should be removed.
The remote operates within a range of 8 meters (26 ft.) from the receiver located inside the main unit. Any
obstruction between the receiver and remote may cause signal interference, limiting the ability to program the
unit.
3) Re-install rear cover.
4) If the remote control will not be used for extended periods of time (vacations, etc.),
batteries should be removed.
The remote operates within a range of 8 meters (26 ft.) from the receiver located inside the main unit. Any
obstruction between the receiver and remote may cause signal interference, limiting the ability to program the
unit.