Graco 247444 Benutzerhandbuch

(See F

. 3 below)

1.

Loosen grounding lug locknut (A) and washer (B). 

2.

Insert one end of a 12 gage (1.5 mm

2

) minimum 

ground wire (C) into slot in lug (D). Tighten locknut 
securely.

3.

Connect other end of wire to true earth ground. To 
order a ground wire and clamp, order part number 
222011.

(See F

. 4, page 8)

Mount Reservoir (P) on sturdy, flat surface with 6 (six), 
3/8-inch diameter bolts. Note location of Fill Port (K), 
Hydraulic Lines (A) and Lubricant Outlet Connection (C) 
for easy access once installed.

1.

Install Ball Valve (AA) (user provided) in the 3/8-inch 
High Pressure Hydraulic Line (X).

2.

Connect the 3/8-inch High Pressure Hydraulic Line 
(X) to the High Pressure Hydraulic Connection 
swivel (Y).

3.

Connect the 3/4-inch Hydraulic Tank Line (T) to the 
Tank Hydraulic Connection swivel (Z).

4.

Connect the 24 VDC timer controlled signal to the 
3-way Solenoid Valve (F).

5.

Connect High Pressure Lubricant Supply Line (G) to 
the Lubricant Output Connection (C) for Single Line 
Parallel Systems or to Pressure Relief Kit Output 
Connection for Single Line, Series 
Progressive-based Systems.

6.

Ground system (see GROUNDING). Mount 
Reservoir (P) to grounded chassis member.

(Unless otherwise indicated, see F

. 6, page 

1.

Weld the bracket (F

. 7, page 10) in place per 

recommended configuration for mounting the vent 
valve. Paint the bracket if desired.

2.

Connect the Hydraulic Control Line (A) to control 
module Vent Valve Hydraulic Control (J).

3.

Connect Pump Output Connection line (C) to Pump 
outlet.

4.

Connect the High Pressure Lubricant Supply Line 
(G, F

. 4, page 8) feeding the injector system to the 

Lubricant Output (E).

5.

Connect the Vent Line (F) to Custom Tank (user 
provided).

•

Be sure unit is securely mounted before operation.

•

Do not lift pressurized equipment.

•

The hydraulic system must be depressurized before con-
necting High Pressure Hydraulic Lines (A).

•

Be sure Breather (M) is not plugged before filling Reser-
voir (P).

A

C

B

D

ti0720

The hydraulic supply must be 10

µ filtered or better and sup-

ply 0.5 - 3.0 gpm (1.9 - 11.4 lpm) at 300 psi - 3500 psi (21 
bar - 241 bar (2.1 MPa - 24 MPa).