MTD YM2BP Benutzerhandbuch

Place a hose clamp over 
the end of the Flex Tube 
and slide the end of the 
with the clamp on it over 
the elbow tube. Tighten 
the clamp screw.

Place a hose clamp over 
the other end of Flex Tube 
and slide the end over the 
top end of the upper 
blower tube. Tighten the 
clamp screw.

Loosen the 2 screws on 
the throttle control. Move 
the throttle control to the 
position that provides the 
best grip and tighten.

Mix thoroughly in separate 
fuel can:
  –  3.2 fl. oz. of 2-cycle 

NOTE: Do not mix directly 

in fuel tank.

Press primer bulb 10 
times, or until fuel is 
visible

Move choke lever to 
Position 1.

Press down cruise control 
to FAST position.

Crouch in starting 
position.

Pull rope 5 times.

Move choke lever to 
Position 2 .

Remove all contents from 
the carton.

Insert the upper blower 
tube into the lower blower 
tube and twist the lower 
tube clockwise unit it locks 
into place.

Place unit on a level 
surface and fill fuel tank. 
DO NOT overfill.

Repeat these instructions.

IF the engine hesitates, return the choke lever to 

Position 2 and continue the warm-up.

IF the engine does not start, go back to step 9.

IF the unit fails to start after 2 attempts, move choke 

lever to Position 3 and pull rope until unit starts

Move choke lever to 
Position 3.

Continue to keep the 
cruise control in FAST 
position and warm unit for 
an additional 60 seconds 
to complete warm-up. Unit 
may be used during this 
time.

Pull rope 3-5 times to 
start engine. Keep the 
cruise control in FAST 
position and allow unit to 
warm up for 30 to 60 
seconds.

Phillips Screwdriver
T-20 Torx

®

 Screwdriver 

Insert the lower blower 
tube into the nozzle and 
twist the nozzle clockwise 
until it locks into place. 
Zip tie the throttle cable to 
the elbow tube.       

Release your hand from 
the trigger or raise the 
cruise control. Allow the 
engine to cool down by 
idling.

Press the On/Off Switch 
in the OFF (O) position 
and hold until the engine 
comes to a complete 
stop.