Quadra-Fire 21M-ACC Benutzerhandbuch

May 5, 2011

7039-131H

Page 11

R

FLOOR PROTECTION:  Floor protector must be non-com-

bustible material, extending beneath heater and to the front,

sides and rear as indicated. The floor must be non-com-

bustible or otherwise adequately protected from radiant heat

given off by the unit and from sparks and falling embers. A

layer of thin brick or ceramic tile over a combustible floor is

not sufficient.
In US installations, it is necessary to install a floor protector

of a minimum of 3/8 inch (9.5mm) thick metal clad millboard

or equivalent a minimum of 16 inches (406mm) in front of

glass and 8 inches (203mm) to both sides of the fuel loading

door. Open the door and measure 8 inches (203mm) from

the side edge of the opening in the face of the appliance.

*

16" from glass

8 in.

Fuel loading door

5-3/4 in. 2-1/4 in."

29-5/8 in.

minimum

39 in.

minimum

29

-5/

8 i

n.

25

-3/

8 i

n.

32-7/8 in.

39

in.

3 in.

13

5°

op

tio

na

l

co

ve

rag

e

50-3/4 in.

Must extend 2 in. (51mm) beyond 

each side of pipe (shaded area) 

203mm (8 in.) 

203mm 

(8 in.) 

203mm 

(8 in.) 

457mm (18 in.) 

1244mm 

(49 in.)

minimum

1000mm (39-3/8 in.)

minimum

In  Canada,  similar  floor  protection  must  be  provided  18

inches (457mm) in front and 8 inches (203mm) from the

sides and rear of the stove. *

*EXCEPTION:    Non-combustible  floor  protections  must

extend beneath the flue pipe when installed with horizontal

venting  and  extend  2  inches  (51mm)  beyond  each  side.

•  Hearth pads must be installed exactly as 

specified.

High temperatures or hot embers may ignite 

concealed combustibles.

•  Illustrations and photos reflect typical installations and are FOR DESIGN PURPOSES ONLY.

•  I

llustrations/diagrams are not drawn to scale.

•  Actual installation may vary due to individual design preference

•  Hearth & Home Technologies reserves the right to alter its products.