England's Stove Works 10-CPM Benutzerhandbuch
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND’S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE
TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.
4
12.
Keep corn, pellets and all other combustible materials a safe distance from the unit.
13.
This unit will require floor protection if installed on a combustible surface. The minimum
floor protector for this unit is 36” x 48” which should give you at least six inches (6”) of
protection at the rear and at each side, and six inches (6”) minimum in the front of the unit.
floor protector for this unit is 36” x 48” which should give you at least six inches (6”) of
protection at the rear and at each side, and six inches (6”) minimum in the front of the unit.
14.
Horizontal runs should not exceed four feet (4’) with a maximum vertical flue height of thirty
five feet (35’). At fifteen feet (15’), the pipe should be increased to four inch (4”) corn vent
pipe.
five feet (35’). At fifteen feet (15’), the pipe should be increased to four inch (4”) corn vent
pipe.
15.
This unit should be turned off and allowed to cool prior to cleaning. Any ashes should be
kept in an airtight metal container and not disposed of until they are completely cooled.
kept in an airtight metal container and not disposed of until they are completely cooled.
16.
Read the instructions thoroughly, including instructions concerning the digital control
board, and save them for future reference.
board, and save them for future reference.
17.
Do not allow paint, chemicals or construction dust on or near your unit. Do not allow liquid
or ANY foreign materials on or inside your unit. Shut your unit down and cover it when
painting, construction or similar activity is taking place. Wipe and clean your unit after any
construction is done in your home, or if any foreign material gets on or inside your unit.
You may also need to remove the rear and side cover plates to your unit (unplug unit first)
and vacuum and clean the motors and inside of your unit.
or ANY foreign materials on or inside your unit. Shut your unit down and cover it when
painting, construction or similar activity is taking place. Wipe and clean your unit after any
construction is done in your home, or if any foreign material gets on or inside your unit.
You may also need to remove the rear and side cover plates to your unit (unplug unit first)
and vacuum and clean the motors and inside of your unit.
18.
Improper gasket maintenance, including failure to replace gaskets, can cause air leaks
resulting in smoke-backs.
resulting in smoke-backs.
19.
Remember that, as with any appliance, there is user responsibility involved, including
installation, operation and maintenance of this product. Be sure to check local codes, and
call Technical Support at (800) 245-6489 if you have any questions.
installation, operation and maintenance of this product. Be sure to check local codes, and
call Technical Support at (800) 245-6489 if you have any questions.
20.
Be sure to follow the directions of all manufacturers of third party products that you
use, including exhaust pipe, etc. Never apply firestarter products (including gel) to a
hot surface or hot coals.
use, including exhaust pipe, etc. Never apply firestarter products (including gel) to a
hot surface or hot coals.
21.
Basement Installation: Basement installation should be performed only by a professional
installer. For basement installations, a three inch (3”) pipe and coupler must be used for
Outside Combustion Air, and a minimum clearance of three feet (3’) must be maintained
from the ground to the corn vent exhaust pipe outside the dwelling. Keep in mind that each
elbow used reduces draft by up to 30%; it is good practice to add three feet (3’) of vertical
rise for each elbow used. Example: After the 2
installer. For basement installations, a three inch (3”) pipe and coupler must be used for
Outside Combustion Air, and a minimum clearance of three feet (3’) must be maintained
from the ground to the corn vent exhaust pipe outside the dwelling. Keep in mind that each
elbow used reduces draft by up to 30%; it is good practice to add three feet (3’) of vertical
rise for each elbow used. Example: After the 2
nd
elbow used, add six feet (6’) of vertical
rise before terminating your vent pipe.
22.
DANGER! Do not open the door on this unit if the Stirrer is still moving! See instructions
on “Setting the Stirrer” later in this manual. See burnpot installation pictures.
on “Setting the Stirrer” later in this manual. See burnpot installation pictures.
IMPORTANT NOTICE:
This unit must be properly installed to prevent the possibility of a house fire or “smoke-
back.” The instructions must be strictly adhered to.
Do not use makeshift methods or material which may compromise the installation.
Your unit requires periodic maintenance and cleaning (refer to manual). Failure to
maintain your unit may lead to a variety of problems, including but not limited to smoke
spillage into the home. England’s Stove Works will not be liable for consequential or
indirect damages to property or persons resulting from the use of this product.
back.” The instructions must be strictly adhered to.
Do not use makeshift methods or material which may compromise the installation.
Your unit requires periodic maintenance and cleaning (refer to manual). Failure to
maintain your unit may lead to a variety of problems, including but not limited to smoke
spillage into the home. England’s Stove Works will not be liable for consequential or
indirect damages to property or persons resulting from the use of this product.