Drolet HT-1600 Benutzerhandbuch
24
RELOADING
Once you have obtained a good bed of embers, you should reload the unit. In order to do
so, open the air controls to maximum a few seconds prior to opening the stove's door. Then
proceed by opening the door very slowly; open it one or two inches for 5 to 10 seconds,
before opening it completely to increase the draught and thus eliminate the smoke which is
stagnant in a state of slow combustion in the stove. Then bring the red embers to the front
of the stove and reload the unit.
so, open the air controls to maximum a few seconds prior to opening the stove's door. Then
proceed by opening the door very slowly; open it one or two inches for 5 to 10 seconds,
before opening it completely to increase the draught and thus eliminate the smoke which is
stagnant in a state of slow combustion in the stove. Then bring the red embers to the front
of the stove and reload the unit.
For optimal operation of your wood stove, we recommend you operate it with a wood load
approximately equivalent to the height of fire bricks.
approximately equivalent to the height of fire bricks.
It is important to note that wood combustion consumes ambient oxygen in the room .In the
case of negative pressure, it is a good idea to allow fresh air in the room, either by opening
a window slightly or by installing a fresh air intake system on an outside wall. Refer to page
16 of the present manual.
case of negative pressure, it is a good idea to allow fresh air in the room, either by opening
a window slightly or by installing a fresh air intake system on an outside wall. Refer to page
16 of the present manual.
WARNINGS
•
N
EVER OVERFIRE YOUR STOVE
. I
F ANY PART OF THE STOVE STARTS TO GLOW RED
,
OVER FIRING
IS HAPPENING
. R
EADJUST THE AIR INTAKE CONTROL AT A LOWER SETTING
.
•
T
HE INSTALLATION OF A LOG CRADLE IS NOT RECOMMENDED IN YOUR DROLET WOOD STOVE
.
•
N
EVER PUT WOOD ABOVE THE FIREBRICK LINING OF THE FIREBOX
.
CREOSOTE FORMATION AND NEED FOR REMOVAL
When wood is burned slowly, it produces tar and other organic vapours, which combine with
expelled moisture to form creosote. The creosote vapours condense in the relatively cool
chimney flue of a slow-burning fire. As a result, creosote residue accumulates on the flue
lining. When ignited this creosote makes an extremely hot fire. When burning wood, the
chimney connector and chimney should be inspected at least once every two months during
the heating season to determine if a creosote build-up has occurred.
expelled moisture to form creosote. The creosote vapours condense in the relatively cool
chimney flue of a slow-burning fire. As a result, creosote residue accumulates on the flue
lining. When ignited this creosote makes an extremely hot fire. When burning wood, the
chimney connector and chimney should be inspected at least once every two months during
the heating season to determine if a creosote build-up has occurred.
We strongly recommend that you install a magnetic thermometer on your smoke exhaust
pipe, approximately 18" above the stove. This thermometer will indicate the temperature of
your gas exhaust fumes within the smoke exhaust system. The ideal temperature for these
gases is somewhere between 275
pipe, approximately 18" above the stove. This thermometer will indicate the temperature of
your gas exhaust fumes within the smoke exhaust system. The ideal temperature for these
gases is somewhere between 275
o
F and 500
o
F. Below these temperatures, the build-up
of creosote is promoted. Above 500 degrees, heat is wasted since a too large quantity is
lost into the atmosphere.
lost into the atmosphere.
TO PREVENT CREOSOTE BUILD UP
•
Always burn dry wood. This allows clean burns and higher chimney temperatures,
therefore less creosote deposit.
therefore less creosote deposit.
•
Leave the air control fully open for about 10 min. every time you reload the stove to
bring it back to proper operating temperatures. The secondary combustion can only
take place if the firebox is hot enough.
bring it back to proper operating temperatures. The secondary combustion can only
take place if the firebox is hot enough.
•
Always check for creosote deposit once every two months and have your chimney
cleaned at least once a year.
cleaned at least once a year.