Sylvania EN-ECU-G4-P3D Benutzerhandbuch

Page 1 of 4

76-015-DA 10/13

OSRAM and Logo are registered trademarks of OSRAM GmbH.
ENCELIUM and Polaris 3D are registered trademarks of OSRAM SYLVANIA, Inc
GreenBus II are trademarks of OSRAM SYLVANIA, Inc.
SEE THE WORLD IN A NEW LIGHT is a registered trademark of OSRAM SYLVANIA, Inc.

The Energy Control Unit (ECU) is a gateway that
interfaces to both IT equipment (servers, LAN, etc) and
field bus devices (luminaire controllers, sensors, wall
switches, etc).  Communication with IT equipment and
other ECUs is achieved using the Ethernet port.
Additionally, two USB 2.0 ports are provided for data
transfer and back-up purposes.

The ECU provides operating power together with
communication signals via GreenBus II

to the various

field bus devices of the system via eight GreenBus II

communication channels.

The ECU makes each device addressable via GreenBus II

(e.g. each light fixture can be individually dimmed and

turned on/off). Devices will obtain their addresses during the commissioning process and no actions are required
during installation.

The following model(s) are available:

Indoor Locations:

EN-ECU-G4-P3D

When using electrical equipment, basic safety precautions should always be followed including the following:

• READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
• Do not let power supply cords touch hot surfaces.
• Do not mount near gas or electric heaters.
• Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by

unauthorized personnel.

• The use of accessory equipment is not recommended by OSRAM Sylvania as it may cause an unsafe condition.
• Do not use this equipment for other than the intended use.

SAVE THESE INSTRUCTIONS

Important Safeguards

Overview

ENCELIUM

™

Energy Management System

Energy Control Unit

Wiring and Installation Manual