Lightolier IS:40825 Merkblatt

This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

LIGHTOLIER a GENLYTE company.
631 Airport Road, Fall River, MA  02720

NOTE: This instruction sheet covers several fixture
styles. Backplate, lamp type and diffuser assembly
may vary slightly from that shown, although installa-
tion is the same.
BACKPLATE INSTALLATION:

1. Thread CROSSBAR MOUNTING SCREWS into CROSSBAR as

shown (Fig. 1).

2. Using appropriate slots in CROSSBAR, secure CROSSBAR to

OUTLET BOX using OUTLET BOX  SCREWS (provided with
OUTLET BOX.)

3. While supporting BACKPLATE ASSEMBLY make connections:

black fixture lead or fixture lead without tracer marks to hot
(black) supply lead; white fixture lead or fixture lead with trac-
er marks to neutral (white) supply lead. Uninsulated fixture
wire is a ground wire and must be connected to grounding ter-
minal or ground lead inside OUTLET BOX. Use WIRE NUTS
(local hardware item). Push supply wires and connections back
into OUTLET BOX.

4. Position BACKPLATE over CROSSBAR

allowing CROSSBAR MOUNTING SCREWS 
to come through holes in BACKPLATE ASSEMBLY.

5. Secure BACKPLATE ASSEMBLY in position by installing two

BATTERY NUTS over CROSSBAR MOUNTING SCREWS and
tighten.

6. Install recommended lamp(s).

DIFFUSER INSTALLATION:

1. Slide DIFFUSER down into NOTCHES in BACKPLATE ASSEM-

BLY until DIFFUSER rests in slot in support arm.

2. Secure DIFFUSER in position by tightening four DIFFUSER

MOUNTING SCREWS through holes in BACKPLATE ASSEM-
BLY against DIFFUSER. (Caution: Diffuser damage may occur;
do not over tighten diffuser mounting screws.)

OUTLET BOX

WIRE NUT

GROUND WIRE

CROSS BAR

CROSS BAR 

MOUNTING SCREW

OUTLET BOX SCREW

(PROVIDED WITH OUTLET BOX)

BATTERY NUT

SUPPORT ARM

SLOT

NOTCH

DIFFUSER

MOUNTING

SCREW

BACKPLATE

ASSEMBLY

DIFFUSER

FIG. 1

®