American Standard 2650 Benutzerhandbuch

7 3 0 5 1 3 - 1 0 0   R E V .   D

RUBBER 
GASKET

TANK MTG.
BOLTS PRE-
INSTALLED

NUT

WASHER

a.

Install caps on washers.  (If necessary, cut bolt height 

to size before installing caps.)  

b.

Smooth off the bead of sealant around base. Remove 

excess sealant.

INSTALL TANK
a.

Install large rubber gasket over 

threaded outlet on bottom of tank 
and lower tank onto bowl so that 
tapered end of gasket fits evenly into 
bowl water inlet opening, and tank 
mounting bolts go through mounting 
holes. Secure with metal washers 
and nuts.

b.

With tank parallel to wall, alternately 

tighten nuts until tank is snugged 
down evenly against bowl surface.

INSTALL TANK
a.

Install large rubber gasket over 

threaded outlet on bottom of tank 
and lower tank onto bowl so that 
tapered end of gasket fits evenly into 
bowl water inlet opening.

b.

Insert tank mounting bolts and 

rubber washers from inside tank, 
through mounting holes, and secure 
with metal washers and nuts.

c.

With tank parallel to wall, alternately 

tighten nuts until tank is snugged 
down evenly against bowl surface.

INSTALL TOILET SEAT  Install toilet seat in accordance with manufacturer's directions.

CLOSET

BOLT

CLOSET

BOLT

NUT

WASHER

BOLT CAP

RUBBER 
GASKET

TANK MTG.

BOLTS

NUT

WASHER

!

-   2   -

DO NOT OVERTIGHTEN NUTS MORE

THAN REQUIRED FOR A SNUG FIT!

!

DO NOT OVERTIGHTEN NUTS MORE

THAN REQUIRED FOR A SNUG FIT!

For Tanks/Bowls using Speed
Connect System (Tank 
mounting bolts pre-installed).

For all other Tanks/Bowls

RUBBER
WASHER

Before continuing, determine the type of water supply connecation you have from 
the chart below and use the appropriate assembly parts required to properly 
reconnect the water supply. DO NOT use plumber's putty to seal these fittings.

These parts must be used as 
illustrated to insure water-tight 
connection. Use of existing 
coupling nut may result in 
water leakage. Water supply 
tube or pipe must extend at 
least 1/2" inside threaded 
shank of valve (does not apply 
to flanged tubing).

Use existing 
coupling nut 
and washer.

Use existing spiral 
cone washer. 
Fluidmaster cone 
washer may not 
seal completely on 
spiral type supply 
line.

Captive cone 
washers already 
included. No 
additional washers 
needed.

LOCK NUT

LOCK NUT

LOCK NUT

LOCK NUT

COUPLING
NUT

COUPLING
NUT

EXISTING
COUPLING
NUT

COUPLING
NUT

WATER
SHUT-OFF

WATER
SHUT-OFF

WATER
SHUT-OFF

WATER
SHUT-OFF

CONE
WASHER

EXISTING
CONE
WASHER

EXISTING
WASHER

With correct washers in place 
(see Step 9a), tighten 
COUPLING NUT 1/4 turn beyond 
hand tight. DO NOT 
OVERTIGHTEN.

NUT

WASHER

COVER
MTG. CLIP

COVER

a.

Press covers over mounting clips.  (If necessary, 

cut bolt height to size before installing covers.)  

b.

Smooth off the bead of sealant around base. 

Remove excess sealant.

INSTALL BOLTS AND CAPS