Alvin LB1620 Merkblatt

LB1218

11

15

⁄

16

" x 17

15

⁄

16

"

LB1620

15

15

⁄

16

" x 19

15

⁄

16

"

LB1824

17

15

⁄

16

" x 23

15

⁄

16

"

LB2436

23

15

⁄

16

" x 35

15

⁄

16

"

LB1218

650

1  F15T8

650

LB1620

650

2  F15T8

1300

LB1824

650

2  F15T8

1300

LB2436

1750

3  F30T8

5100

All electrical components are U.L. listed.

• Double-strength window glass*       • Thickness: 

1

⁄

8

"       • Chamfer smooth all edges

* It is best to purchase glass from a glass dealer rather than a hardware or home center.

It is highly recommended that these dimensions be 

double-checked against your lightbox before cutting glass.

1. To install glass, remove the two aluminum 

strips on the top surface of the lightbox. For 
your own safety, use gloves when handling 
glass. Place the glass on top of the Plexiglas 
sheet and replace the aluminum strips.

2. To operate, depress the on/off switch and 

hold for one or two seconds until the lights 
illuminate. Note: Bulbs may loosen during 
shipping. If bulbs don’t illuminate check that 
they are properly seated in fixture.

3. The Satin-Glow Lightbox is designed to 

operate on 110V AC, 60 cycle. Please do 
not use any other power source.

4. Removal of the back panel or tampering 

with the electrical circuitry will void the 
warranty and releases the manufacturer 
from all responsibility for damages, loss 
of property and/or personal injury.

4. Remove the hold-down screws and lift 

off the light diffusers.

5. Remove and replace fluorescent tubes.
6. Return diffusers, glass and Plexiglas 

panels to their original positions. 
Re-install aluminum strips and screws.

1. “Daylight” bulbs with CRI of 70 or 

greater are recommended. Always use 
direct replacement lamps in order to 
prevent overheating.

2. Disconnect the power cord.
3. Remove the screws and aluminum strips from 

the top surface of the lightbox. Carefully 
remove glass and Plexiglas panels.

Bloomfield, CT

Grand Prairie, TX