Magenta XR2000 Benutzerhandbuch
.
7
CHAPTER 3: SETUP & INSTALLATION
3. Setup and Installation
3.1 Data Mode Configuration
SA series offer RS232 serial in addition to stereo audio. The serial signal is 3 wire TX,
RX, GND and does not support full modem signals. Baud rates for the SA series are
fixed at 9600. Simplex modes are supported without jumper or other changes by simply
using the TX signal only. SA units require no configuration.
SAP series offer pollable RS232 serial in addition to stereo audio. The serial signal is 3
wire TX, RX, GND and does not support full modem signals. Baud rates for the SAP
series are fixed at 9600. Simplex modes are supported without jumper or other changes
by simply using the TX signal only. See Appendix F on configuration and use of SAP
Series.
RX, GND and does not support full modem signals. Baud rates for the SA series are
fixed at 9600. Simplex modes are supported without jumper or other changes by simply
using the TX signal only. SA units require no configuration.
SAP series offer pollable RS232 serial in addition to stereo audio. The serial signal is 3
wire TX, RX, GND and does not support full modem signals. Baud rates for the SAP
series are fixed at 9600. Simplex modes are supported without jumper or other changes
by simply using the TX signal only. See Appendix F on configuration and use of SAP
Series.
3.2 Cabling Considerations
• We recommend mounting and connecting all cabling to the Magenta MultiView Series
components before applying power.
• Makes sure that the CAT5 cable you intend to use has been tested to comply
with the TIA/EIA 568B wiring specification (See Appendix A).
components before applying power.
• Makes sure that the CAT5 cable you intend to use has been tested to comply
with the TIA/EIA 568B wiring specification (See Appendix A).
3.3 Making the Connections
3.3.1 CONNECTIONS AND SETUP IN GENERAL
This section contains figures showing connections with the specific Magenta MultiView
Series models. In general, however, the connection and setup procedure at both
transmitter and receiver ends is as follows:
NOTE: all units must be the same type for all supported features to function correctly.
For example, a UTX set for R/L summed audio must be connected to an XR2000 set for
R/L summed audio. Similarly, A UTX SA cannot be used with an XR2000A. Video
modes may function normally, but 4th pair options will not.
At the transmitter end (refer to the transmitter user guide) :
1. Connect the source video to the Magenta MultiView Series transmitter video input
port, which is an HD15 connector labeled SOURCE IN.
2. If desired, attach a local monitor via the local monitor port to LOCAL OUT
3. Make your audio or serial connections via the phoenix connector or DB9 connector
as appropriate.
Series models. In general, however, the connection and setup procedure at both
transmitter and receiver ends is as follows:
NOTE: all units must be the same type for all supported features to function correctly.
For example, a UTX set for R/L summed audio must be connected to an XR2000 set for
R/L summed audio. Similarly, A UTX SA cannot be used with an XR2000A. Video
modes may function normally, but 4th pair options will not.
At the transmitter end (refer to the transmitter user guide) :
1. Connect the source video to the Magenta MultiView Series transmitter video input
port, which is an HD15 connector labeled SOURCE IN.
2. If desired, attach a local monitor via the local monitor port to LOCAL OUT
3. Make your audio or serial connections via the phoenix connector or DB9 connector
as appropriate.
5