Troy-Bilt 3310XP Benutzerhandbuch

1. 

Remove the chute crank rod from the chute crank assembly by 
removing the hair pin clip shown in Figure 7-1. Move the chute 
crank rod away from the assembly as shown. 

2. 

Remove the plastic belt cover on the front of the engine by 
removing the three self-tapping screws. See Figure 7-2.

3. 

Loosen the bolt shown in Figure 7-3 securing the belt keeper 
bracket and remove the other bolt. Push the belt keeper 
bracket up off the engine pulley. 

To remove and replace your snow thrower’s auger belt, proceed 
as follows:
1. 

Remove the bow tie clip and flat washer from the ferrule 
in order to disconnect the auger idler rod from the brake 
bracket assembly. See Figure 7-4.

Ferrule

Auger Idler Rod

Hairpin Clip 
and Washer

NOTE: Make sure to maintain the location of the ferrule on 
the idler rod. 

2. 

Slip the auger control belt (the front belt) off the engine 
pulley.