Shindaiwa 81719 Benutzerhandbuch

8

WARNING! Never start the en-
gine from  the operating position.



  After the engine starts, allow the engine 

to warm up at idle  or  minutes before 

operating the unit. 



  Advancing the throttle makes the cut-

ting attachment turn faster; releasing 

the throttle permits the attachment to 

stop turning. If the cutting attachment 

continues to rotate when the engine 

returns to idle, carburetor idle speed 

should be adjusted (see “Adjusting 

Engine Idle” below).

IMPORTANT!

If the engine fails to start after several at-
tempts with the choke in the closed posi-

tion, the engine may be flooded with fuel. 

If flooding is suspected, move the choke 
lever to the open position and repeatedly 
pull the recoil starter to remove excess 
fuel and start the engine. If the engine still 
fails to start, refer to the troubleshooting 
section of this manual. 

7.  Operating the throttle will automatically 

disengage the fast idle setting.

WARNING!
The cutting attachment may 

rotate when the engine is started!

6.  When the engine starts, slowly move the 

choke lever to the “OPEN” position. See 

Figure 1. (If the engine stops after the 

initial start, close the choke and restart.) 

XST011

 

 

Starting the Engine 

.  Press the primer bulb until fuel can be seen 

flowing in the transparent return tube.

IMPORTANT!!

Engine ignition is controlled by a two position switch mounted on the throttle housing labeled, “I” for ON or START and  “O” for OFF or STOP.

IMPORTANT!

The primer system only pushes fuel 
through the carburetor. Repeatedly 

pressing the primer bulb will not flood the 
engine with fuel.

5.  While holding the outer tube firmly 

with left hand. Use your other hand to 

slowly pull the recoil starter handle until 

resistance is felt, then pull quickly to 

start the engine.

CAUTION! 
Do not pull the recoil starter to the end 
of the rope travel. Pulling the recoil 
starter to the end of the rope travel 
can damage the starter.

ON

1.  Slide the ignition switch to the “ON” 

position. See Figure 9.

.  Set the throttle lever to the “fast idle”;
 

a. Squeeze the throttle lever toward the 

handgrip on the shaft tube.

 b. Depress and hold the throttle lock button.
 c. While depressing the throttle lock 

button, release the throttle lever.  See 

Figure 9.

4.  Set the choke lever to the CLOSED 

position if engine is cold.