Runco SC-50D Benutzerhandbuch

• Make sure that there is nothing obstructing the infrared beam between the remote 

control and the IR receiver on the DHD Controller.

• If the effective range of the remote control decreases, or it stops working, replace the 

batteries with new ones.

• The remote control may fail to operate if the infrared remote sensor is exposed to bright 

sunlight or fluorescent lighting.

• Ambient conditions may possibly impede the operation of the remote control. If this 

happens, point the remote control at the DHD Controller, and repeat the operation.

Table 3-1 gives a quick overview of the SC-50d/SC-60d installation process. The sections 
following this one provide detailed instructions. 

➤

Choose a location for the projector

Install primary projection lens

Install CineWide with AutoScope lens motor (optional)

Mount the projector

Connect the DHD Controller to the projector

Connect signal sources to the DHD Controller

Connect other external equipment to DHD Controller (optional):
• Audio processor or secondary display device
• Control system interface (RS-232)
• 12-volt trigger-activated equipment (AutoScope lens motor, 

retractable screens or screen masking etc.)

• External IR repeater
• Network hub, router or gateway (Ethernet)

Apply power to the projector 

Adjust primary lens: projected image size (zoom), position (shift) 
and focus

For rear-screen and/or ceiling-mount installations, select the 
proper picture orientation 

Use Image Alignment controls to fine-tune image geometry

Install CineWide anamorphic lens (optional)

Adjust CineWide anamorphic lens: position, pitch (angle), 
geometry and focus

DHD Controller input calibration: adjust the following for each 
DHD Controller input and display mode (resolution/frame 
rate); save settings when finished:
• Aspect ratio

• Color level

• Brightness

• Tint

• Contrast

• Input position

• Color temperature and white balance

53 through 68