Runco LS-100d Benutzerhandbuch

If you prefer to do this manually, set it to Off. The DHD Controller will ask if you want 
to perform the upgrade the next time it is power-cycled.

• Check For New Firmware: To have the DHD Controller check for new firmware on 

demand (and perform an upgrade if it finds a new version), select Check For New 
Firmware from the Auto Firmware Upgrade menu. If the DHD Controller finds a new 
firmware version, select Yes to perform the upgrade or No to return to the previous 
menu. 

• E-Mail Notification: Select E-Mail Notification from the Network menu to specify 

when and to whom the DHD Controller sends error and service notification messages 
via e-mail.

The notification messages are in the following format:

To:  [E-Mail Address; see below]

From:  do-not-reply@runco.com

Subject:  [Type of notification] from Runco DHD4

Body:  

This is an automated message sent from the Runco DHD4:

Notification:

[One of the following:

“DHD Error” / “Display Error” 

“Periodic Service Notification”

“Lamp Life Notification” / “Calibration Data”]

Detailed Description: [ If a DHD Error, one of the following:

“Fan Failure 1” / “Fan Failure 2”

“Overtemp 1” / “Overtemp 2”

“Initialization Failure”

If a Display Error, a device-specific 

error message such as “Lamp Door Open”

If a Periodic Service Notification, the elapsed

time since the last notification

If a Lamp Life Notification, the number of hours 

the lamp has been in service

“See Attached File” ]

Serial Number:

[DHD Controller serial number]

Customer Information: [From “Customer Information“ sub-menu; 

see below]

Best Regards,

Runco International, LLC

1195 NW Compton Drive

Beaverton, OR 97006

1-800-237-8262

• E-Mail Address: To specify the destination e-mail address for error and service 

notifications, select E-Mail Address from the E-Mail Notification menu. The 
procedure is similar to that for setting the IP address (refer to IP Configuration on 
page 58). Enter up to 45 alphnumeric characters.