Runco RS-900 Series RS1100 Series Betriebsanweisung
6
RS-900 and RS1100 Series Installation/Operation Manual
PRE
L
IMINAR
Y
4.
TEMP LED
Indicates fan status and internal temperature as follows:
• Off during normal operation
• Red when internal temperature is too high or a fan failure occurs
5.
INTAKE VENT
6.
POWER/STANDBY LED
Indicates power status as follows:
• Orange when the projector is in standby mode
• Flashes green for approximately 45 seconds after the projector is turned on to
indicate that the lamp is warming up
• Green during normal operation
• Flashes orange for approximately 110 seconds after the projector is turned off to
indicate that the lamp is cooling down
• Red when an internal failure requiring service has occurred
7.
LAMP LED
Indicates lamp status as follows:
• Off during normal operation
• Red when the lamp has exceeded its usage life or developed a problem
8.
RUNCO LOGO
The logo can be rotated to match the projector orientation: inverted (ceiling-mounted)
or upright. To rotate the logo, grip it at the sides, pull it away from the projector and
rotate it 180 degrees.
or upright. To rotate the logo, grip it at the sides, pull it away from the projector and
rotate it 180 degrees.
9.
FRONT IR SENSOR
10. FOCUS RING (Standard RS-900/RS1100)
To adjust the focus, grasp the lens by the outer ring and rotate it. (Use the remote
control unit to adjust the focus with an RS1100 Ultra.)
control unit to adjust the focus with an RS1100 Ultra.)