Runco RS-900 Series RS1100 Series Betriebsanweisung
RS-900 and RS1100 Series Installation/Operation Manual
45
PRE
L
IMINAR
Y
Whitney (Prismatic)
Anamorphic Lens
Installation and
Adjustment
Anamorphic Lens
Installation and
Adjustment
The Whitney Anamorphic lens mount kit consists of everything shown in Figure 3-22.
Some components shipped with your projector may differ slightly from what is shown in
these instructions.
Some components shipped with your projector may differ slightly from what is shown in
these instructions.
Figure 3-22. Prismatic Anamorphic Lens Mounting Assembly - Exploded View
1.
Use the Pitch Adjustment Screws and Washers (item #6) to attach the Vertical
Mounting Brackets (item #5) to the Anamorphic Lens (item #1).
Mounting Brackets (item #5) to the Anamorphic Lens (item #1).
2.
Place the lens with the brackets installed on top of (or under, if the projector is
inverted) the Base Plate (item #2), so that the two threaded posts at the bottom of the
brackets pass through the corresponding slots on the base plate.
inverted) the Base Plate (item #2), so that the two threaded posts at the bottom of the
brackets pass through the corresponding slots on the base plate.
3.
Secure the lens assembly to the base plate with the Yaw/Z-Adjustment Knobs and
Washers (item #4).
Washers (item #4).
To avoid clipping the corners of the image, position the anamorphic
lens as close as possible to the primary lens.
lens as close as possible to the primary lens.
2 Base Plate
5 Vertical Mounting
Bracket (2x)
Bracket (2x)
6 Pitch/Y-Adjustment
Screw, Phillips
Pan Head, 4-40 x 3/8”
(4x) and Fender
Washer (4x)
Screw, Phillips
Pan Head, 4-40 x 3/8”
(4x) and Fender
Washer (4x)
4 Yaw/Z-Adjustment
Knob (2x) and
Washer (2x)
Knob (2x) and
Washer (2x)
1 Anamorphic Lens
3 Screw, Phillips
M6x16mm (2x) and
1/4” Flat Washer (2x)
(not shown; secures Base Plate
to bottom of projector)
M6x16mm (2x) and
1/4” Flat Washer (2x)
(not shown; secures Base Plate
to bottom of projector)
Tip
Ceiling Mount
Bracket
Bracket