Runco SC-60D Benutzerhandbuch
Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual
7
PRE
L
IMINAR
Y
1.
RS232 IN
Connect the RS-232 output from the DHD Controller here, using the provided
RJ11-to-DB9 adapter and communication cable.
Connect the RS-232 output from the DHD Controller here, using the provided
RJ11-to-DB9 adapter and communication cable.
2.
PWR LED
Lights green to indicate that power is applied and the module is initialized. During
normal operation, always on.
Lights green to indicate that power is applied and the module is initialized. During
normal operation, always on.
3.
1 - Dual-Link DVI-I Input (Slot 2)
HDCP-compliant digital video input. Connect the HDMI output from the DHD
Controller to this input (see Figure 2-4).
HDCP-compliant digital video input. Connect the HDMI output from the DHD
Controller to this input (see Figure 2-4).
4.
Analog LED
Lights briefly when the projector is powered up (self-test). During normal operation,
always off.
Lights briefly when the projector is powered up (self-test). During normal operation,
always off.
5.
Digital LED
Lights green to indicate that a valid digital signal from the DHD Controller is present.
Lights green to indicate that a valid digital signal from the DHD Controller is present.
6.
MAIN POWER SWITCH
Disconnects or applies power to the SC-50d/SC-60d.
Disconnects or applies power to the SC-50d/SC-60d.
7.
POWER INPUT (100 to 240 VAC)
Connect the projector to power here.
Connect the projector to power here.
Use ONLY the AC power cord shipped with the
SC-50d/SC-60d for this purpose (the one with the ferrite
sleeve). Doing otherwise creates a fire hazard risk.
SC-50d/SC-60d for this purpose (the one with the ferrite
sleeve). Doing otherwise creates a fire hazard risk.
WARNING