Shark SV745 Benutzerhandbuch

4. Empty the dust from the dust cup 

container. (See Fig. 10)

5. Rinse the dust cup filter in cold water, 

and then wait until it dries completely 

before replacing it back into the dust 

cup container. Do not use a washing

machine to clean the dust cup filter. 

Do not use a hair dryer to dry it. Air 

6. To empty liquids from the dust cup, 

follow same instructions as above. Do 

not let liquids in dust cup go over the 

"MAX" level on the dust cup. (Fig. 11 

& Fig. 12)

7. Replace the separator housing and the 

dust cup filter carefully into the dust 

cup compartment. NEVER operate 

8. Attach the dust cup container to the 

cordless vacuum.

1. Remove the vacuum cleaner from 

the charging base

2. To start the unit, push the "On/Off" 

switch to the "On" position.

3. To stop the vauum cleaner, slide 

the "On/Off" switch to the "Off" 

position.

Crevice Tool

A crevice tool is provided 

for cleaning narrow, hard 

to reach places. 
Convertible Brush

A convertible brush is 

provided for cleaning 

upholstery, furniture, 

etc.
Squeegee Nozzle

A squeegee nozzle is 

provided for picking up 

any liquid spills.

Fig. 6

4. To use the extension hose with 

convertible brush, crevice tool or 

squeegee nozzle, push the 

smaller end of extension hose 

into the suction hole, then 

push the selected 

accessory into the 

other end. (Fig. 6)

When using this vacuum for wet pick-up, 

NEVER fill past the "MAX" level mark on the 

dust cup housing. Maximum capacity 

(liquid) is 6 US Fl. Oz. (180 ml). Never tip 

the unit upward past horizontal when 

vacuuming liquids. Keep suction inlet 

pointed downward. Always empty the dust 

cup after using the vacuum to pick up 

liquids.

1. To open the dust cup compartment, 

push the dust cup release button 

and  remove the dust cup 

container. (Fig. 2)

2. Verify that the dust cup filter and 

the separator housing are inside, 

then re-attach the dust cup 

container to the wet/dry hand 

vacuum. (Fig. 3 & Fig. 4)

1. This cordless wet/dry hand vacuum is 

powered by rechargeable nickel-

cadmium batteries. Before using the 

vacuum, charge the vacuum cleaner 

for a minimum of 20 hours.

NOTE: Peak performance may only 

be realized after the unit has been 

charged and discharged two (2) or 

three (3) times.

Fig. 2

IMPORTANT: To maintain peak 

performance of your cordless hand 

vacuum, it is recommended that the 

unit be fully discharged, then 

completely re-charged at least once a 

month.

Fig. 3

2. Store the vacuum cleaner in the 

charging base when not in use so that 

it is always charged and ready  to 

use.

Fig. 7

Fig. 8

Fig. 9

Fig. 10

Fig. 11

Fig. 12

1. Place the charging base near an 

electrical power outlet (120 V., 60 Hz.) 

and plug in the charging adapter's jack 

into the charging base.

2. Plug the charger into wall outlet.

3. Place the unit in the charging base. The 

charging indicator light will shine red to 

indicate that the vacuum cleaner is 

properly positioned in the charging base 

and that the unit is being charged. 

(See Fig. 1)

3.  To attach the convertible brush, 

crevice tool or squeegee nozzle to 

the wet/dry hand vacuum, push the 

attachment into the suction hole in 

the front of the dust container. 

(Fig. 5)

Fig. 5

Fig. 4

NOTE: When vacuuming up liquids, 

ensure that you do not go over the 

"MAX" level on the dust cup.  Capacity 

is 6 US Fl. Oz. (180 ml.).

NOTE: It is recommended that the dust 

cup filter be replaced every three (3) 

months to ensure peak performance of 

the unit.

Fig. 1

1. To remove the dust cup container, 

press down on the dust cup release 

button and pull off  the dust cup 

container. (Fig. 7)

2. Pull out the dust cup filter. (Fig. 8)

3. Pull out the separator housing. (Fig. 9)

CAUTION: The suction hole must be 

open and free of any obstructions at all 

times. Otherwise, the motor will 

overheat and could become damaged.