Nilfisk Alto Sweeper PS-27 Benutzerhandbuch

Page 6

  

CLARKE TECHNOLOGY Operator's Manual PS-27

 1. Tip the machine on its side and remove any string that is wrapped around the main sweeping broom.

 2. Lubricate the front caster wheel with light machine oil.

 3. Inspect the rubber skirt on the hopper.  Replace the skirt if it is torn.

 1. Inspect the rubber skirts on each side and behind the sweeping broom.  Replace the skirt if it is torn.

  2. Tip the machine on its side and inspect the main broom for wear.  Replace the broom when the bristles are worn to a length

of 1½ inch (38MM).

  1. The broom roller consists of a broom shaft with three broom supports, one lock washer with a hollow screw and ten (10) broom

assemblies as follows:

(5) broom assemblies with bristles of 0.006 in. (0.15MM).
(5) broom assemblies with bristles of 0.01 in. (0.25MM).

 1. Unscrew the cap screw (Allen Key, 0.2 in. - 5MM).

 2. Turn the lock washer slightly until the notch at the end of the broom assemblies are placed next to each other.

 3. Pull the broom assembly to the left to unlock it from the broom supports on the broom shaft.

  4. Turn the lock washer and remove the broom assembly.

  5. Insert the new broom assemblies onto the shaft so that the 0.006 in. (0.15MM) and 0.01 in (0.25MM) bristles are alternated.