A.O. Smith 28 30 50 60 Benutzerhandbuch

32

Instruction Manual BFC

is

4. Connect the power cord to the main switch.

Leave the appliance disconnected until you are ready to start it up.

5. If you do not need to make any more connections: 

-

Fit the cap on the electrical connection block.

-

Fit the plastic covers onto the appliance.

An isolating transformer should be used if there is a case of “floating neutral”. 
1. Refer to fitting instructions provided with the isolating transformer

(1)

.

2. Connect phase (L), neutral (N) and earth (

A

) of the power cables to 

terminals 16 through 21 of the connector block as indicated in 

3. Fit the cables in the pull relief.
4. If you do not need to make any more connections: 

-

Fit the cap on the electrical connection block.

-

Fit the plastic covers onto the appliance.

5. Connect the power cord to the main switch.

The continuous pump will start up as soon as mains power is connected to the 
appliance.
1. Connect phase (L), neutral (N) and earth (

A

) to terminals 7, 8 and 9 as 

2. Fit the cable in the pull relief.
3. If you do not need to make any more connections: 

-

Fit the cap on the electrical connection block.

-

Fit the plastic covers onto the appliance.

Switching on of the program-controlled pump is determined by settings of the 
ThermoControl.
1. Connect phase (L), neutral (N) and earth (

A

 to terminals 10, 11 and 12 as 

2. Fit the cable in the pull relief.
3. If you do not need to make any more connections: 

-

Fit the cap on the electrical connection block.

-

Fit the plastic covers onto the appliance.

Tank ON is a facility for connecting an external ON/OFF switch. In the OFF 
position, the programmed operating mode is active. In the ON position, the 
programmed operating mode is overruled, and the “ON mode” is active.
1. Connect cables (X

1

 and X

2

) to terminals 5 and 6 as indicated in 

.

2. Fit the cable in the pull relief.