Sears 153.321342 Benutzerhandbuch

Seite von 32
8
Mineral buildup or sediment may have accumulated in the old 
water heater. This causes the water heater to be much heavier than 
normal and this residue, if spilled out, could cause staining.
Facts to Consider About the Location
you should carefully choose an indoor location for the new water 
heater, because the placement is a very important consideration 
for the safety of the occupants in the building and for the most 
economical  use  of  the  appliance. 
This  water  heater  is  not 
intended for outdoor installation.
Whether  replacing  an  old  water  heater  or  putting  the  water 
heater in a new location, the following critical points must be 
observed.
•   The location selected should be indoors as close to and as 
centralized with the water piping system as possible. This 
water heater, as well as all water heaters, will eventually leak. 
Do not install without adequate drainage provisions so water 
flow will not cause damage.
WATER HEATERS EVENTUALLy LEAK: Installation of the water 
heater must be accomplished in such a manner that if the tank 
or any connections should leak, the flow of water will not cause 
damage to the structure. When such locations cannot be avoided, 
a suitable drain pan should be installed under the water heater. 
Drain pans are available at your local Sears stores. Such drain 
pans must be piped to an adequate drain.
Water heater life depends upon water quality, water pressure 
and the environment in which the water heater is installed. Water 
heaters are sometimes installed in locations where leakage may 
result in property damage, even with the use of a drain pan piped 
to a drain. However, unanticipated damage can be reduced or 
prevented by a leak detector or water shut-off device used in 
conjunction with a piped drain pan. These devices are available 
from some plumbing supply wholesalers and retailers, and detect 
and react to leakage in various ways:
• Sensors  mounted  in  the  drain  pan  that  trigger  an  alarm  or 
turn off the incoming water to the water heater when leakage  
is detected.
• Sensors mounted in the drain pan that turn off the water supply 
to the entire home when water is detected in the drain pan.
• Water supply shut-off devices that activate based on the water 
pressure differential between the cold water and hot water pipes 
connected to the water heater.
INSTALLATION IN RESIDENTIAL GARAGES: The water heater 
must be located and/or protected so it is not subject to physical 
damage by a moving vehicle.
•  The  location  selection  must  provide  adequate  clearances  
for servicing and proper operation of the water heater.
Insulation Blankets
Insulation blankets are available to the general public for external 
use on electric water heaters but are not necessary with this 
product.   The  purpose  of  an  insulation  blanket  is  to  reduce 
the standby heat loss encountered with storage tank heaters.  
your  water  heater  meets  or  exceeds  the  National Appliance 
Energy Conversation Act standards with respect to insulation 
and standby loss requirements, making an insulation blanket 
unnecessary.
Should you choose to apply an insulation blanket to this heater, 
you  should  follow  these  instructions  below.  Failure  to  follow 
these instructions can result in fire, serious personal injury, or 
death.
•  Do not cover the temperature and pressure relief (T & P) valve 
with an insulation blanket.
•  Do not cover the instruction manual.  Keep it on the side of 
the water heater or nearby for future reference.
•  Do obtain new warning and instruction labels for placement 
on the blanket directly over the existing labels.
Facts to Consider About the  
Convertible Lower Element
The Upper Element (if a double element model) is a conventional 
3800 watt element which only operates at its rated wattage on 
240 volts. (See rating plate on the water heater).
The Lower Element of the water heater can be converted from 
operation at 3800 watts to 5500 watts on a 240 volt system.
Read and follow water heater warnings and instructions. If after 
reading these instructions in this manual, you do not understand 
any portion, call Sears Service Center.