A&D ML-50 Benutzerhandbuch

MS-70 / MX-50 / MF-50 / ML-50

11. Open the heater cover. Put in a sample using the

level indicator.

Caution

The sample needs to be more than 0.1 g.

Spread

the

sample

evenly.

12. If the

↑

key is pressed during gram display, analysis

mode, measurement unit and minimum scale value
are displayed. If the

ENTER

key is pressed,

sample mass is output.

Star

Start the Measurement

t the Measurement

13. Close the heater cover. Press the

START

key

after a stable value is displayed.

14. If

the

SELECT

key is pressed during measurement,

other units can be displayed temporarily and its
measurement values can be output.

Caution

Do not press the

SELECT

key while

sampling data.

Finish the Measurement

15. When the change of moisture content per one

minute (drying rate) reaches the preset termination
value, the measurement is completed and the
buzzer beeps.

16. Open the heater cover and remove the sample

using the pan handle.

17. Press the following key to return to gram display.

ENTER

key..... Outputs (Prints) result.

SELECT

key ... Returns to the weighing mode.

RESET

key ..... Returns to the weighing mode and

displays zero.

18. If the same condition is used, proceed to step 8.

If changing the condition, proceed to step 2.

The sample pans can be washed and reused.

There is the Reference card on the bottom of the analyzer.

No good

Good

Remove sample

Drying temperature

Analysis time

Drying rate

Result

Sample needs more than 0.1 g.
Significant sample is indicated
segment.

Range of proper sample