A&D MS-70 Benutzerhandbuch

MS-70 / MX-50 / MF-50 / ML-50

15.5.

15.5. Error Message

Error Message

CH no Internal Error

An internal error indicated by the result of the self-check function. If repair is
needed, contact the local A&D dealer.

Cl pf Clock Battery Error

Press any key and input the date and time. Refer to "6.2. Setting the Clock
and Calendar ".

Cl err Clock Error

Contact the local A&D dealer to repair the analyzer.

Clo5e Heater Cover Error

The heater cover is opened when starting self-check function. If it is closed,
the self-check function is started.

error0 Internal Error

Turn the power switch off and then on .
Check the frequency of the power supply.
Contact the local A&D dealer to repair the analyzer, if the error is not cleared.

error3   IC Error
error8   Contact the local A&D dealer to repair the analyzer.
error9

Ht err Temperature Control Error

Contact the local A&D dealer to repair the analyzer, if an error is not cleared
when turning the power switch off for more than a half hour and rechecking it.

t-Up Time Error at Temperature Calibration

There is no key operation for five minutes during temperature calibration.

If pressing any key, the weighing mode is displayed.

e Positive Overload, Overweight

The sample has exceeded the weighing capacity.

If the weighing sample pan is empty and this error is displayed, contact the
local A&D dealer to repair the analyzer.

-e Negative Overload, Sample Pan Error

The weight value is too light.

Check the pan, pan support and press the

RESET

key.

Calibrate the weighing sensor.

If an error can be not cleared, contact the local A&D dealer to repair the analyzer.

Full

Memory

The number of results stored in memory has reached the upper limit.

Clear the data to store the new results. Refer to "12. Data Memory Function".

MEM

fUl